Water hardness in Whitman County, WA

Water in Whitman County is moderately hard, with a median of 114 mg/L (6.7 grains per gallon) across 13 monitoring sites.

54% harder than the Washington median (74 mg/L) 10th hardest of 35 counties
114mg/L
6.7 grains per gallon
Moderately hard

Whitman County water at a glance

  • HardnessModerately hard (114 mg/L, 6.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 114 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.7 gpg (6.4 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites13
Lab samples45
Sample years2000–2016
Middle 50% of sites110–197 mg/L
Groundwater (wells, springs)132 mg/L · 11 sites
Surface water (rivers, lakes)112 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Whitman County

Prefilled with Whitman County's measured local hardness of 114 mg/L (6.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Whitman County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Whitman County

PlaceMedian mg/LClassBased on
Pullman 114 Moderately hard county median
Colfax 122 Hard 4 sites within 10 miles
Palouse 114 Moderately hard county median
Tekoa 114 Moderately hard county median
Rosalia 114 Moderately hard county median
St. John 114 Moderately hard county median
Garfield 110 Moderately hard 5 sites within 10 miles
Albion 111 Moderately hard 3 sites within 10 miles
Colton 114 Moderately hard county median
Oakesdale 110 Moderately hard 3 sites within 10 miles
Uniontown 197 Very hard 3 sites within 10 miles
Endicott 114 Moderately hard county median
LaCrosse 114 Moderately hard county median
Malden 114 Moderately hard county median
Steptoe (CDP) 110 Moderately hard 3 sites within 10 miles
Farmington 110 Moderately hard 3 sites within 10 miles
Lamont 114 Moderately hard county median

Water quality in Whitman County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Pullman City of Pullman Water Department None detected 0 lead · 0 unknown None
Colfax City of Colfax Water Department None detected 0 lead · 721 unknown None
Palouse City of Palouse Water Dept Not tested 0 lead · 92 unknown None
Tekoa City of Tekoa Not tested 1 lead · 342 unknown None
Rosalia Town of Rosalia Not tested 0 lead · 0 unknown None
St. John Town of ST John Not tested 0 lead · 0 unknown None
Garfield Garfield Water Department Not tested 0 lead · 0 unknown None
Albion Albion Water Dept Not tested 0 lead · 0 unknown None
Colton Colton Water Department Not tested 0 lead · 0 unknown None
Oakesdale Town of Oakesdale Not tested Not reported None
Uniontown Uniontown Water Works Not tested 0 lead · 0 unknown None
Endicott Endicott Water Dept Not tested Not reported None
LaCrosse Town of Lacrosse Not tested 0 lead · 230 unknown None
Malden Malden Water Dept Not tested 0 lead · 0 unknown None
Steptoe Steptoe Water/Sewer District Not tested 0 lead · 70 unknown None
Farmington Farmington Water Dept Not tested 0 lead · 90 unknown None
Lamont Lamont Water System Not tested Not reported None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next