Water hardness in Ferry County, WA
Water in Ferry County is moderately hard, with a median of 106 mg/L (6.2 grains per gallon) across 13 monitoring sites.
Ferry County water at a glance
- HardnessModerately hard (106 mg/L, 6.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 106 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.2 gpg (5.9 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Ferry County
Prefilled with Ferry County's measured local hardness of 106 mg/L (6.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Ferry County on the Washington map
Cities and communities in Ferry County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Republic | 106 | Moderately hard | county median |
| Curlew Lake (CDP) | 106 | Moderately hard | county median |
| Inchelium (CDP) | 135 | Hard | 6 sites within 10 miles |
| Keller (CDP) | 114 | Moderately hard | 5 sites within 10 miles |
| Barney's Junction (CDP) | 106 | Moderately hard | county median |
| Pine Grove (CDP) | 106 | Moderately hard | county median |
| Curlew (CDP) | 106 | Moderately hard | county median |
| Orient (CDP) | 106 | Moderately hard | county median |
| Barstow (CDP) | 81 | Moderately hard | 3 sites within 10 miles |
| Twin Lakes (CDP) | 180 | Hard | 5 sites within 10 miles |
| Torboy (CDP) | 106 | Moderately hard | county median |
| Boyds (CDP) | 81 | Moderately hard | 3 sites within 10 miles |
| Danville (CDP) | 106 | Moderately hard | county median |
| Malo (CDP) | 106 | Moderately hard | county median |
| Laurier (CDP) | 106 | Moderately hard | county median |
Water quality in Ferry County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Republic | City of Republic | Not tested | 0 lead · 80 unknown | None |
| Inchelium | Inchelium Water District | Not tested | 0 lead · 0 unknown | 1 |
| Curlew | Curlew Water & Sewer District | Not tested | 0 lead · 3 unknown | None |
Neighboring counties
- Stevens County73 mg/L
- Okanogan County94 mg/L
- Lincoln County178 mg/L
- Douglas County68 mg/L
- Spokane County24 mg/L
- Grant County176 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.