Water hardness in Chelan County, WA

Water in Chelan County is soft, with a median of 10 mg/L (0.6 grains per gallon) across 2 monitoring sites.

86% softer than the Washington median (74 mg/L) 34th hardest of 35 counties
10mg/L
0.6 grains per gallon
Soft

Chelan County water at a glance

  • HardnessSoft (10 mg/L, 0.6 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 10 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.6 gpg (0.6 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites2
Lab samples7
Sample years2009–2010
Middle 50% of sites7–13 mg/L
Surface water (rivers, lakes)10 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Chelan County

Prefilled with Chelan County's measured local hardness of 10 mg/L (0.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Chelan County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Chelan County

PlaceMedian mg/LClassBased on
Wenatchee 67 Moderately hard 11 sites within 10 miles
Chelan 10 Soft county median
Cashmere 66 Moderately hard 10 sites within 10 miles
Sunnyslope (CDP) 67 Moderately hard 11 sites within 10 miles
Leavenworth 10 Soft county median
South Wenatchee (CDP) 67 Moderately hard 11 sites within 10 miles
Manson (CDP) 10 Soft county median
Entiat 10 Soft county median
Chelan Falls (CDP) 10 Soft county median

Water quality in Chelan County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Wenatchee City of Wenatchee None detected 0 lead · 0 unknown None
Chelan City of Chelan Water Dept None detected 1 lead · 1,595 unknown None
Cashmere Cashmere Water Department Not tested 0 lead · 6 unknown None
Sunnyslope Sunnyslope Not tested Not reported None
Leavenworth City of Leavenworth Not tested 0 lead · 810 unknown None
Entiat City of Entiat Not tested 0 lead · 18 unknown None
Chelan Falls Chelan Falls Water District Not tested 0 lead · 0 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next