Water hardness in Stevens County, WA
Water in Stevens County is moderately hard, with a median of 73 mg/L (4.3 grains per gallon) across 15 monitoring sites.
Stevens County water at a glance
- HardnessModerately hard (73 mg/L, 4.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 73 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.3 gpg (4.1 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Stevens County
Prefilled with Stevens County's measured local hardness of 73 mg/L (4.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Stevens County on the Washington map
Cities and communities in Stevens County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Colville | 73 | Moderately hard | county median |
| Chewelah | 73 | Moderately hard | county median |
| Kettle Falls | 73 | Moderately hard | county median |
| Loon Lake (CDP) | 73 | Moderately hard | county median |
| Clayton (CDP) | 73 | Moderately hard | county median |
| Northport | 70 | Moderately hard | 9 sites within 10 miles |
| Springdale | 73 | Moderately hard | county median |
| Addy (CDP) | 73 | Moderately hard | county median |
| Marcus | 73 | Moderately hard | county median |
| Valley (CDP) | 73 | Moderately hard | county median |
| Suncrest (CDP) | 73 | Moderately hard | county median |
Water quality in Stevens County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Colville | Colville Water Department | None detected | 0 lead · 1,861 unknown | None |
| Kettle Falls | Kettle Falls Water Dept | Not tested | Not reported | None |
| Northport | Northport Water System | Not tested | 0 lead · 0 unknown | 1 |
| Springdale | Town of Springdale | Not tested | Not reported | None |
| Marcus | Marcus Water Dept | Not tested | 0 lead · 0 unknown | None |
| Valley | Valley Water System | Not tested | 0 lead · 545 unknown | None |
Neighboring counties
- Ferry County106 mg/L
- Spokane County24 mg/L
- Lincoln County178 mg/L
- Okanogan County94 mg/L
- Douglas County68 mg/L
- Adams County233 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.