Water hardness in Okanogan County, WA
Water in Okanogan County is moderately hard, with a median of 94 mg/L (5.5 grains per gallon) across 76 monitoring sites.
Okanogan County water at a glance
- HardnessModerately hard (94 mg/L, 5.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 94 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.5 gpg (5.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Okanogan County
Prefilled with Okanogan County's measured local hardness of 94 mg/L (5.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Okanogan County on the Washington map
Cities and communities in Okanogan County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Omak | 216 | Very hard | 7 sites within 10 miles |
| Okanogan | 218 | Very hard | 8 sites within 10 miles |
| Brewster | 119 | Moderately hard | 3 sites within 10 miles |
| Oroville | 93 | Moderately hard | 3 sites within 10 miles |
| Tonasket | 94 | Moderately hard | county median |
| Twisp | 92 | Moderately hard | 23 sites within 10 miles |
| North Omak (CDP) | 230 | Very hard | 6 sites within 10 miles |
| Pateros | 130 | Hard | 5 sites within 10 miles |
| Winthrop | 84 | Moderately hard | 27 sites within 10 miles |
| Malott (CDP) | 220 | Very hard | 3 sites within 10 miles |
| Riverside | 230 | Very hard | 4 sites within 10 miles |
| Nespelem Community (CDP) | 100 | Moderately hard | 14 sites within 10 miles |
| Elmer City | 106 | Moderately hard | 12 sites within 10 miles |
| Conconully | 94 | Moderately hard | county median |
| Nespelem | 102 | Moderately hard | 13 sites within 10 miles |
| Loomis (CDP) | 94 | Moderately hard | county median |
| Disautel (CDP) | 120 | Moderately hard | 3 sites within 10 miles |
| Methow (CDP) | 156 | Hard | 6 sites within 10 miles |
Water quality in Okanogan County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Omak | City of Omak | 1 found | 0 lead · 0 unknown | None |
| Okanogan | City of Okanogan Water Department | Not tested | 0 lead · 0 unknown | None |
| Brewster | City of Brewster | Not tested | 0 lead · 0 unknown | None |
| Oroville | City of Oroville | Not tested | 0 lead · 0 unknown | None |
| Tonasket | Tonasket Water System | Not tested | 0 lead · 0 unknown | None |
| Twisp | Town of Twisp | Not tested | 0 lead · 0 unknown | None |
| Pateros | Pateros Water Department | Not tested | Not reported | None |
| Winthrop | Town of Winthrop | Not tested | Not reported | None |
| Riverside | Town of Riverside | Not tested | 0 lead · 0 unknown | None |
| Elmer City | Elmer City Water System | Not tested | 0 lead · 0 unknown | None |
| Nespelem | Nespelem Water Dept | Not tested | 0 lead · 232 unknown | None |
| Methow | Methow Water System INC | Not tested | Not reported | None |
Neighboring counties
- Ferry County106 mg/L
- Douglas County68 mg/L
- Chelan County10 mg/L
- Stevens County73 mg/L
- Lincoln County178 mg/L
- Grant County176 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.