Water hardness in Skagit County, WA
Water in Skagit County is soft, with a median of 9 mg/L (0.5 grains per gallon) across 8 monitoring sites.
Skagit County water at a glance
- HardnessSoft (9 mg/L, 0.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 9 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.5 gpg (0.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Skagit County
Prefilled with Skagit County's measured local hardness of 9 mg/L (0.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Skagit County on the Washington map
Cities and communities in Skagit County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Mount Vernon | 9 | Soft | county median |
| Anacortes | 9 | Soft | county median |
| Sedro-Woolley | 9 | Soft | county median |
| Burlington | 9 | Soft | county median |
| Big Lake (CDP) | 9 | Soft | county median |
| Clear Lake (CDP) | 9 | Soft | county median |
| La Conner | 9 | Soft | county median |
| Concrete | 9 | Soft | county median |
| Bay View (CDP) | 9 | Soft | county median |
| Lyman | 9 | Soft | county median |
| Alger (CDP) | 9 | Soft | county median |
| Hamilton | 9 | Soft | county median |
| Marblemount (CDP) | 9 | Soft | county median |
| Lake McMurray (CDP) | 38 | Soft | 55 sites within 10 miles |
| Lake Cavanaugh (CDP) | 23 | Soft | 21 sites within 10 miles |
| Edison (CDP) | 9 | Soft | county median |
| Rockport (CDP) | 9 | Soft | county median |
| Conway (CDP) | 45 | Soft | 34 sites within 10 miles |
| Bow (CDP) | 9 | Soft | county median |
Water quality in Skagit County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Anacortes | City of Anacortes | None detected | 0 lead · 7,858 unknown | None |
| Clear Lake | Clear Lake Water District | Not tested | 0 lead · 89 unknown | None |
| La Conner | La Conner Water Dept | Not tested | 0 lead · 0 unknown | None |
| Concrete | Concrete Utilities | Not tested | 0 lead · 431 unknown | 1 |
| Lyman | Lyman Water Department | Not tested | 0 lead · 94 unknown | None |
| Hamilton | Hamilton Water Department | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Whatcom County125 mg/L
- Snohomish County31 mg/L
- Island County289 mg/L
- San Juan County163 mg/L
- King County61 mg/L
- Chelan County10 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.