Water hardness in Spokane County, WA
Water in Spokane County is soft, with a median of 24 mg/L (1.4 grains per gallon) across 37 monitoring sites.
Spokane County water at a glance
- HardnessSoft (24 mg/L, 1.4 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 24 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.4 gpg (1.3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Spokane County
Prefilled with Spokane County's measured local hardness of 24 mg/L (1.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Spokane County on the Washington map
Cities and communities in Spokane County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Spokane | 70 | Moderately hard | 6 sites within 10 miles |
| Spokane Valley | 22 | Soft | 30 sites within 10 miles |
| Liberty Lake | 22 | Soft | 29 sites within 10 miles |
| Cheney | 24 | Soft | county median |
| Airway Heights | 90 | Moderately hard | 6 sites within 10 miles |
| Fairwood (CDP) | 70 | Moderately hard | 6 sites within 10 miles |
| Mead (CDP) | 70 | Moderately hard | 6 sites within 10 miles |
| Otis Orchards-East Farms (CDP) | 22 | Soft | 29 sites within 10 miles |
| Country Homes (CDP) | 70 | Moderately hard | 6 sites within 10 miles |
| Medical Lake | 24 | Soft | county median |
| Deer Park | 24 | Soft | county median |
| Town and Country (CDP) | 70 | Moderately hard | 6 sites within 10 miles |
| Fairchild AFB (CDP) | 90 | Moderately hard | 4 sites within 10 miles |
| Millwood | 24 | Soft | 24 sites within 10 miles |
| Green Bluff (CDP) | 24 | Soft | county median |
| Fairfield | 24 | Soft | county median |
| Rockford | 24 | Soft | county median |
| Four Lakes (CDP) | 90 | Moderately hard | 4 sites within 10 miles |
| Spangle | 24 | Soft | county median |
| Latah | 24 | Soft | county median |
| Waverly | 24 | Soft | county median |
Water quality in Spokane County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Spokane | City of Spokane | 4 found (PFOA ND / PFOS 6.1 ppt) | 0 lead · 0 unknown | None |
| Liberty Lake | Liberty Lake Sewer & Water District | 1 found | 0 lead · 0 unknown | None |
| Cheney | City of Cheney | None detected | 0 lead · 81 unknown | None |
| Airway Heights | City of Airway Heights | 4 found | 1,777 lead · 426 unknown | None |
| Medical Lake | City of Medical Lake | 2 found (PFOA ND / PFOS 4.4 ppt) | 0 lead · 0 unknown | None |
| Deer Park | City of Deer Park | 3 found (PFOA ND / PFOS 7.5 ppt) | Not reported | None |
| Millwood | City of Millwood | Not tested | 0 lead · 0 unknown | 1 |
| Fairfield | Town of Fairfield | Not tested | 0 lead · 130 unknown | None |
| Rockford | Town of Rockford | Not tested | 0 lead · 0 unknown | None |
| Four Lakes | Four Lakes | Not tested | 0 lead · 0 unknown | None |
| Spangle | Town of Spangle | Not tested | 0 lead · 60 unknown | None |
| Latah | Town of Latah | Not tested | Not reported | None |
| Waverly | Town of Waverly | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Lincoln County178 mg/L
- Whitman County114 mg/L
- Stevens County73 mg/L
- Adams County233 mg/L
- Ferry County106 mg/L
- Garfield County114 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.