Water hardness in Thurston County, WA

Water in Thurston County is soft, with a median of 58 mg/L (3.4 grains per gallon) across 18 monitoring sites.

22% softer than the Washington median (74 mg/L) 22nd hardest of 35 counties
58mg/L
3.4 grains per gallon
Soft

Thurston County water at a glance

  • HardnessSoft (58 mg/L, 3.4 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 58 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.4 gpg (3.2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites18
Lab samples46
Sample years2000–2016
Middle 50% of sites48–71 mg/L
Groundwater (wells, springs)58 mg/L · 16 sites
Surface water (rivers, lakes)42 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Thurston County

Prefilled with Thurston County's measured local hardness of 58 mg/L (3.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Thurston County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Thurston County

PlaceMedian mg/LClassBased on
Lacey 58 Soft 18 sites within 10 miles
Olympia 57 Soft 17 sites within 10 miles
Tumwater 58 Soft 16 sites within 10 miles
Yelm 65 Moderately hard 12 sites within 10 miles
Tanglewilde (CDP) 56 Soft 20 sites within 10 miles
Grand Mound (CDP) 58 Soft county median
North Yelm (CDP) 60 Moderately hard 14 sites within 10 miles
Rainier 64 Moderately hard 6 sites within 10 miles
Rochester (CDP) 58 Soft county median
Tenino 58 Soft county median
Bucoda 58 Soft county median
Nisqually Indian Community (CDP) 50 Soft 59 sites within 10 miles

Water quality in Thurston County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Lacey Lacey Water Department 4 found 0 lead · 0 unknown None
Olympia City of Olympia 5 found (PFOA 4.3 / PFOS 5.8 ppt) 0 lead · 0 unknown None
Tumwater City of Tumwater 1 found 0 lead · 0 unknown None
Yelm City of Yelm None detected 0 lead · 0 unknown None
Grand Mound Grand Mound Not tested 0 lead · 0 unknown None
Rainier Rainier Water Department Not tested 0 lead · 3 unknown None
Rochester Rochester Not tested 0 lead · 0 unknown None
Tenino City OF Tenino None detected 0 lead · 0 unknown None
Bucoda Bucoda Water Dept Not tested 0 lead · 13 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next