Water hardness in Franklin County, WA

Water in Franklin County is very hard, with a median of 240 mg/L (14 grains per gallon) across 29 monitoring sites.

224% harder than the Washington median (74 mg/L) 2nd hardest of 35 counties
240mg/L
14 grains per gallon
Very hard

Franklin County water at a glance

  • HardnessVery hard (240 mg/L, 14 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 240 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 14 gpg (13.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites29
Lab samples96
Sample years2000–2023
Middle 50% of sites164–328 mg/L
Groundwater (wells, springs)254 mg/L · 28 sites
Surface water (rivers, lakes)55 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Franklin County

Prefilled with Franklin County's measured local hardness of 240 mg/L (14 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Franklin County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Franklin County

PlaceMedian mg/LClassBased on
Pasco 278 Very hard 12 sites within 10 miles
Connell 240 Very hard county median
West Pasco (CDP) 235 Very hard 14 sites within 10 miles
Basin City (CDP) 240 Very hard 13 sites within 10 miles
Mesa 196 Very hard 6 sites within 10 miles
Kahlotus 240 Very hard county median

Water quality in Franklin County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Pasco Pasco Water Department None detected 0 lead · 10,550 unknown None
Connell City of Connell None detected Not reported None
Basin City Basin City Water Sewer District Not tested 0 lead · 0 unknown 3
Mesa Mesa Water Department Not tested 0 lead · 0 unknown None
Kahlotus City of Kahlotus Not tested 0 lead · 0 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next