Water hardness in Cowlitz County, WA

Water in Cowlitz County is soft, with a median of 16 mg/L (0.9 grains per gallon) across 3 monitoring sites.

78% softer than the Washington median (74 mg/L) 31st hardest of 35 counties
16mg/L
0.9 grains per gallon
Soft

Cowlitz County water at a glance

  • HardnessSoft (16 mg/L, 0.9 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 16 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.9 gpg (0.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites3
Lab samples13
Sample years2000–2012
Middle 50% of sites15–28 mg/L
Surface water (rivers, lakes)16 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Cowlitz County

Prefilled with Cowlitz County's measured local hardness of 16 mg/L (0.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Cowlitz County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Cowlitz County

PlaceMedian mg/LClassBased on
Longview 16 Soft county median
Kelso 16 Soft county median
Longview Heights (CDP) 16 Soft county median
Kalama 16 Soft county median
Castle Rock 16 Soft county median
Ryderwood (CDP) 16 Soft county median
Beacon Hill (CDP) 16 Soft county median
Cougar (CDP) 16 Soft county median
Lexington (CDP) 16 Soft county median

Water quality in Cowlitz County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Longview Longview Water Department None detected 0 lead · 33 unknown None
Kelso City of Kelso None detected 0 lead · 4,746 unknown None
Kalama City of Kalama None detected 0 lead · 1,699 unknown None
Castle Rock Castle Rock Municipal Water None detected 0 lead · 0 unknown None
Beacon Hill Beacon Hill Water & Sewer District None detected 0 lead · 0 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next