Water hardness in Mason County, WA

Water in Mason County is soft, with a median of 40 mg/L (2.3 grains per gallon) across 44 monitoring sites.

46% softer than the Washington median (74 mg/L) 27th hardest of 35 counties
40mg/L
2.3 grains per gallon
Soft

Mason County water at a glance

  • HardnessSoft (40 mg/L, 2.3 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 40 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.3 gpg (2.2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites44
Lab samples211
Sample years2001–2023
Middle 50% of sites29–46 mg/L
Groundwater (wells, springs)45 mg/L · 21 sites
Surface water (rivers, lakes)31 mg/L · 23 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Mason County

Prefilled with Mason County's measured local hardness of 40 mg/L (2.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Mason County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Mason County

PlaceMedian mg/LClassBased on
Shelton 33 Soft 9 sites within 10 miles
Belfair (CDP) 38 Soft 34 sites within 10 miles
Allyn (CDP) 41 Soft 29 sites within 10 miles
Grapeview (CDP) 42 Soft 23 sites within 10 miles
Union (CDP) 37 Soft 30 sites within 10 miles
Skokomish (CDP) 37 Soft 20 sites within 10 miles
Hoodsport (CDP) 34 Soft 24 sites within 10 miles

Water quality in Mason County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Shelton City of Shelton None detected 0 lead · 2,881 unknown None
Union Union Not tested 0 lead · 0 unknown None
Hoodsport Hoodsport Not tested 0 lead · 0 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next