Water hardness in Kittitas County, WA
Water in Kittitas County is soft, with a median of 44 mg/L (2.6 grains per gallon) across 23 monitoring sites.
Kittitas County water at a glance
- HardnessSoft (44 mg/L, 2.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 44 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.6 gpg (2.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Kittitas County
Prefilled with Kittitas County's measured local hardness of 44 mg/L (2.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Kittitas County on the Washington map
Cities and communities in Kittitas County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Ellensburg | 44 | Soft | county median |
| Cle Elum | 32 | Soft | 12 sites within 10 miles |
| Kittitas | 44 | Soft | county median |
| Roslyn | 28 | Soft | 8 sites within 10 miles |
| South Cle Elum | 32 | Soft | 12 sites within 10 miles |
| Easton (CDP) | 28 | Soft | 8 sites within 10 miles |
| Snoqualmie Pass (CDP) | 44 | Soft | county median |
| Ronald (CDP) | 71 | Moderately hard | 8 sites within 10 miles |
| Thorp (CDP) | 92 | Moderately hard | 4 sites within 10 miles |
| Vantage (CDP) | 44 | Soft | county median |
Water quality in Kittitas County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Ellensburg | Ellensburg Water Dept | None detected | 0 lead · 2,871 unknown | None |
| Cle Elum | Cle Elum Water Department | Not tested | 0 lead · 991 unknown | None |
| Kittitas | City of Kittitas | Not tested | 0 lead · 0 unknown | None |
| Roslyn | City of Roslyn | Not tested | 0 lead · 617 unknown | None |
| South Cle Elum | South Cle Elum Water Dept | Not tested | Not reported | None |
| Easton | Easton Water District | Not tested | 0 lead · 0 unknown | None |
| Snoqualmie Pass | Snoqualmie Pass Utility District | None detected | 0 lead · 22 unknown | None |
| Vantage | Vantage Water System | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Yakima County178 mg/L
- Chelan County10 mg/L
- Grant County176 mg/L
- King County61 mg/L
- Douglas County68 mg/L
- Pierce County51 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.