Water hardness in Yelm, WA

Water in Yelm is moderately hard, with a median of 65 mg/L (3.8 grains per gallon) across 12 monitoring sites within 10 miles.

about the same as the Washington median (74 mg/L) 60th hardest of 122 Washington towns Population 10,780
65mg/L
3.8 grains per gallon
Moderately hard

Yelm tap water at a glance

  • HardnessModerately hard (65 mg/L, 3.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 65 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.8 gpg (3.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites12
Lab samples32
Sample years2000–2016
Middle 50% of sites49–80 mg/L
Groundwater (wells, springs)68 mg/L · 11 sites
Surface water (rivers, lakes)26 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Yelm

Prefilled with Yelm's measured local hardness of 65 mg/L (3.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Yelm tap water

City of Yelm is the main public water system for Yelm. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Oct 2024 – Apr 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Yelm

City of Yelm reported 3,598 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
3,598not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Yelm drinking water violations

EPA records show no health-based violations for City of Yelm since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Yelm

SiteTypeDistanceMedianSamplesYears
17N/02E-03J03
USGS Washington Water Science Center
Well 6.1 mi79 mg/L12016
18N/01W-36B01 UR-12
USGS Washington Water Science Center
Well 6.8 mi47 mg/L92000–2012
16N/02E-20N01 SU-011
USGS Washington Water Science Center
Well 6.8 mi71 mg/L12016
18N/01W-26N04 UR-01
USGS Washington Water Science Center
Well 7.9 mi90 mg/L12005
18N/01W-13R01 UR-10
USGS Washington Water Science Center
Well 8.2 mi68 mg/L12005
18N/01W-33R01 UR-05
USGS Washington Water Science Center
Well 8.5 mi57 mg/L12005

Water hardness in towns near Yelm

TownDistanceMedianClass
Lacey10 mi 58 mg/LSoft
Fort Lewis11 mi 51 mg/LSoft
Tumwater13 mi 58 mg/LSoft
Olympia14 mi 57 mg/LSoft
Elk Plain15 mi 54 mg/LSoft
Spanaway15 mi 52 mg/LSoft
Lakewood16 mi 51 mg/LSoft
Frederickson17 mi 52 mg/LSoft
Parkland17 mi 52 mg/LSoft
Graham18 mi 59 mg/LSoft

Thurston County

Yelm is in Thurston County, where the median is 58 mg/L (soft) across 18 sites.

See all of Thurston County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Yelm, WA water: common questions

Do I need a water softener in Yelm?

Probably not. Water measured around Yelm is 3.8 gpg (65 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Yelm's drinking water?

The main public water system serving Yelm in EPA records is City of Yelm. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Yelm?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next