Water hardness in Kings County, NY
Water in Kings County is moderately hard, with a median of 81 mg/L (4.7 grains per gallon) across 4 monitoring sites.
Kings County water at a glance
- HardnessModerately hard (81 mg/L, 4.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 81 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.7 gpg (4.5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Kings County
Prefilled with Kings County's measured local hardness of 81 mg/L (4.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Kings County on the New York map
Cities and communities in Kings County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| New York | 31 | Soft | 9 sites within 10 miles |
Water quality in Kings County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| New York | New York City System | None detected | 120,931 lead · 124,917 unknown | 1 (1 open) |
Neighboring counties
- Queens County212 mg/L
- Bronx County226 mg/L
- Nassau County50 mg/L
- Rockland County100 mg/L
- Westchester County150 mg/L
- Putnam County68 mg/L
New York
The statewide median is 77 mg/L (moderately hard) from 2,847 sites.
New York hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.