Water hardness in Clinton County, NY
Water in Clinton County is moderately hard, with a median of 79 mg/L (4.6 grains per gallon) across 44 monitoring sites.
Clinton County water at a glance
- HardnessModerately hard (79 mg/L, 4.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 79 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.6 gpg (4.4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Clinton County
Prefilled with Clinton County's measured local hardness of 79 mg/L (4.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Clinton County on the New York map
Cities and communities in Clinton County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Plattsburgh | 104 | Moderately hard | 13 sites within 10 miles |
| Dannemora | 79 | Moderately hard | 10 sites within 10 miles |
| Rouses Point | 105 | Moderately hard | 12 sites within 10 miles |
| Keeseville (CDP) | 64 | Moderately hard | 14 sites within 10 miles |
| Cumberland Head (CDP) | 104 | Moderately hard | 11 sites within 10 miles |
| Peru (CDP) | 64 | Moderately hard | 15 sites within 10 miles |
| Morrisonville (CDP) | 92 | Moderately hard | 14 sites within 10 miles |
| Plattsburgh West (CDP) | 84 | Moderately hard | 14 sites within 10 miles |
| Champlain | 105 | Moderately hard | 12 sites within 10 miles |
| Altona (CDP) | 77 | Moderately hard | 3 sites within 10 miles |
| Chazy (CDP) | 105 | Moderately hard | 14 sites within 10 miles |
| Au Sable Forks (CDP) | 24 | Soft | 25 sites within 10 miles |
| West Chazy (CDP) | 127 | Hard | 15 sites within 10 miles |
| Redford (CDP) | 73 | Moderately hard | 9 sites within 10 miles |
| Mooers (CDP) | 127 | Hard | 11 sites within 10 miles |
| Lyon Mountain (CDP) | 77 | Moderately hard | 6 sites within 10 miles |
| Parc (CDP) | 76 | Moderately hard | 14 sites within 10 miles |
| Cadyville (CDP) | 73 | Moderately hard | 13 sites within 10 miles |
Water quality in Clinton County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Plattsburgh | Plattsburgh City | 1 found | 3 lead · 230 unknown | None |
| Dannemora | Dannemora Village | Not tested | 0 lead · 0 unknown | None |
| Rouses Point | Rouses Point Village WD | Not tested | Not reported | 2 (1 open) |
| Peru | Peru WD | Not tested | 0 lead · 596 unknown | None |
| Morrisonville | Morrisonville Water District | Not tested | 0 lead · 0 unknown | None |
| Champlain | Champlain Village | Not tested | 0 lead · 326 unknown | None |
| Chazy | Chazy Water District | Not tested | 0 lead · 0 unknown | 1 |
| Redford | Redford Water District | Not tested | 0 lead · 0 unknown | None |
| Cadyville | Cadyville Water District | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Franklin County32 mg/L
- Essex County17 mg/L
- St. Lawrence County29 mg/L
- Warren County30 mg/L
- Hamilton County6 mg/L
- Herkimer County7 mg/L
New York
The statewide median is 77 mg/L (moderately hard) from 2,847 sites.
New York hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.