Water hardness in Fulton County, NY

Water in Fulton County is soft, with a median of 37 mg/L (2.1 grains per gallon) across 23 monitoring sites.

52% softer than the New York median (77 mg/L) 47th hardest of 60 counties
37mg/L
2.1 grains per gallon
Soft

Fulton County water at a glance

  • HardnessSoft (37 mg/L, 2.1 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 37 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.1 gpg (2.1 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites23
Lab samples68
Sample years2002–2022
Middle 50% of sites7–143 mg/L
Groundwater (wells, springs)80 mg/L · 13 sites
Surface water (rivers, lakes)4 mg/L · 10 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Fulton County

Prefilled with Fulton County's measured local hardness of 37 mg/L (2.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Fulton County on the New York map

Suffolk CountyCortland CountySchenectady CountyGenesee CountyChenango CountyYates CountyWyoming CountyChemung CountyLivingston CountyWashington CountyKings CountyWayne CountyOswego CountyOntario CountyLewis CountySteuben CountyChautauqua CountyCattaraugus CountyMonroe CountyAlbany CountyAllegany CountyMontgomery CountyUlster CountySeneca CountyEssex CountyCayuga CountyColumbia CountyDutchess CountyHerkimer CountyOtsego CountyRockland CountyRensselaer CountyWarren CountySaratoga CountyDelaware CountyRichmond CountySt. Lawrence CountyMadison CountySchoharie CountyOneida CountyTompkins CountyFranklin CountySullivan CountyBroome CountyTioga CountyNew York CountyJefferson CountyNassau CountyPutnam CountyQueens CountySchuyler CountyOrleans CountyBronx CountyGreene CountyClinton CountyHamilton CountyOrange CountyOnondaga CountyErie CountyWestchester CountyNiagara County

Cities and communities in Fulton County

PlaceMedian mg/LClassBased on
Gloversville 203 Very hard 11 sites within 10 miles
Johnstown 218 Very hard 10 sites within 10 miles
Dolgeville 37 Soft 11 sites within 10 miles
Broadalbin 137 Hard 13 sites within 10 miles
Northville 13 Soft 20 sites within 10 miles
Mayfield 143 Hard 10 sites within 10 miles
Caroga Lake (CDP) 34 Soft 11 sites within 10 miles

Water quality in Fulton County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Gloversville Gloversville (C) Water Works None detected 1,297 lead · 327 unknown None

Neighboring counties

New York

The statewide median is 77 mg/L (moderately hard) from 2,847 sites.

New York hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next