Water hardness in Franklin County, NY

Water in Franklin County is soft, with a median of 32 mg/L (1.9 grains per gallon) across 45 monitoring sites.

58% softer than the New York median (77 mg/L) 49th hardest of 60 counties
32mg/L
1.9 grains per gallon
Soft

Franklin County water at a glance

  • HardnessSoft (32 mg/L, 1.9 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 32 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.9 gpg (1.8 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites45
Lab samples152
Sample years2004–2020
Middle 50% of sites11–67 mg/L
Groundwater (wells, springs)58 mg/L · 17 sites
Surface water (rivers, lakes)13 mg/L · 28 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Franklin County

Prefilled with Franklin County's measured local hardness of 32 mg/L (1.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Franklin County on the New York map

Suffolk CountyCortland CountySchenectady CountyGenesee CountyChenango CountyYates CountyWyoming CountyChemung CountyLivingston CountyWashington CountyKings CountyWayne CountyOswego CountyOntario CountyLewis CountySteuben CountyChautauqua CountyCattaraugus CountyMonroe CountyAlbany CountyAllegany CountyMontgomery CountyUlster CountySeneca CountyEssex CountyCayuga CountyColumbia CountyDutchess CountyHerkimer CountyOtsego CountyRockland CountyRensselaer CountyWarren CountySaratoga CountyDelaware CountyRichmond CountySt. Lawrence CountyMadison CountySchoharie CountyOneida CountyTompkins CountySullivan CountyBroome CountyTioga CountyNew York CountyJefferson CountyNassau CountyPutnam CountyQueens CountySchuyler CountyOrleans CountyBronx CountyGreene CountyFulton CountyClinton CountyHamilton CountyOrange CountyOnondaga CountyErie CountyWestchester CountyNiagara County

Cities and communities in Franklin County

PlaceMedian mg/LClassBased on
Malone 143 Hard 5 sites within 10 miles
Saranac Lake 32 Soft 14 sites within 10 miles
Tupper Lake 17 Soft 16 sites within 10 miles
Chateaugay 140 Hard 8 sites within 10 miles
Paul Smiths (CDP) 46 Soft 7 sites within 10 miles
St. Regis Falls (CDP) 52 Soft 4 sites within 10 miles
Brushton 80 Moderately hard 5 sites within 10 miles
Burke 121 Hard 7 sites within 10 miles
Akwesasne (CDP) 74 Moderately hard 16 sites within 10 miles
Fort Covington (CDP) 101 Moderately hard 6 sites within 10 miles

Water quality in Franklin County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
St. Regis Falls ST Regis Falls WD Not tested 0 lead · 173 unknown None
Fort Covington Fort Covington WD Not tested 1 lead · 156 unknown None

Neighboring counties

New York

The statewide median is 77 mg/L (moderately hard) from 2,847 sites.

New York hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next