Water hardness in Columbia County, NY
Water in Columbia County is moderately hard, with a median of 112 mg/L (6.5 grains per gallon) across 15 monitoring sites.
Columbia County water at a glance
- HardnessModerately hard (112 mg/L, 6.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 112 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.5 gpg (6.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Columbia County
Prefilled with Columbia County's measured local hardness of 112 mg/L (6.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Columbia County on the New York map
Cities and communities in Columbia County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Hudson | 112 | Moderately hard | 9 sites within 10 miles |
| Lorenz Park (CDP) | 112 | Moderately hard | 11 sites within 10 miles |
| Valatie | 98 | Moderately hard | 12 sites within 10 miles |
| Niverville (CDP) | 98 | Moderately hard | 14 sites within 10 miles |
| Chatham | 100 | Moderately hard | 11 sites within 10 miles |
| Philmont | 100 | Moderately hard | 9 sites within 10 miles |
| Stottville (CDP) | 102 | Moderately hard | 10 sites within 10 miles |
| Kinderhook | 96 | Moderately hard | 11 sites within 10 miles |
| Claverack-Red Mills (CDP) | 112 | Moderately hard | 9 sites within 10 miles |
| Germantown (CDP) | 140 | Hard | 6 sites within 10 miles |
| Copake Lake (CDP) | 112 | Moderately hard | county median |
| Ghent (CDP) | 100 | Moderately hard | 11 sites within 10 miles |
| Copake (CDP) | 112 | Moderately hard | county median |
| Copake Falls (CDP) | 112 | Moderately hard | county median |
| Taconic Shores (CDP) | 112 | Moderately hard | county median |
Water quality in Columbia County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Hudson | Hudson City | None detected | 254 lead · 1,283 unknown | None |
| Valatie | Valatie Village | Not tested | 0 lead · 75 unknown | None |
| Chatham | Chatham Village | Not tested | 0 lead · 0 unknown | None |
| Philmont | Philmont Village | Not tested | 1 lead · 0 unknown | None |
| Kinderhook | Kinderhook Village | Not tested | 0 lead · 437 unknown | None |
| Taconic Shores | Taconic Shores | Not tested | 0 lead · 238 unknown | None |
Neighboring counties
- Greene County24 mg/L
- Albany County194 mg/L
- Rensselaer County115 mg/L
- Dutchess County141 mg/L
- Ulster County26 mg/L
- Schenectady County216 mg/L
New York
The statewide median is 77 mg/L (moderately hard) from 2,847 sites.
New York hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.