Water hardness in Oswego County, NY
Water in Oswego County is moderately hard, with a median of 81 mg/L (4.7 grains per gallon) across 43 monitoring sites.
Oswego County water at a glance
- HardnessModerately hard (81 mg/L, 4.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 81 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.7 gpg (4.5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Oswego County
Prefilled with Oswego County's measured local hardness of 81 mg/L (4.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Oswego County on the New York map
Cities and communities in Oswego County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Oswego | 197 | Very hard | 7 sites within 10 miles |
| Fulton | 231 | Very hard | 8 sites within 10 miles |
| SUNY Oswego (CDP) | 197 | Very hard | 5 sites within 10 miles |
| Pulaski | 62 | Moderately hard | 24 sites within 10 miles |
| Phoenix | 291 | Very hard | 8 sites within 10 miles |
| Central Square | 107 | Moderately hard | 6 sites within 10 miles |
| Mexico | 105 | Moderately hard | 7 sites within 10 miles |
| Constantia (CDP) | 80 | Moderately hard | 7 sites within 10 miles |
| Minetto (CDP) | 200 | Very hard | 10 sites within 10 miles |
| Sand Ridge (CDP) | 263 | Very hard | 5 sites within 10 miles |
| Cleveland | 71 | Moderately hard | 8 sites within 10 miles |
| Lacona | 58 | Soft | 28 sites within 10 miles |
| Sandy Creek | 58 | Soft | 26 sites within 10 miles |
| Hannibal | 199 | Very hard | 11 sites within 10 miles |
| Parish | 77 | Moderately hard | 12 sites within 10 miles |
| Altmar (CDP) | 62 | Moderately hard | 24 sites within 10 miles |
Water quality in Oswego County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Oswego | Oswego City | None detected | 2,862 lead · 2,947 unknown | None |
| Fulton | Fulton City | None detected | 0 lead · 3,600 unknown | None |
| Pulaski | Pulaski Village | Not tested | 1 lead · 509 unknown | None |
| Phoenix | Phoenix Village | Not tested | 0 lead · 632 unknown | 1 |
| Mexico | Mexico Village | Not tested | 0 lead · 350 unknown | None |
| Cleveland | Cleveland Village | Not tested | 3 lead · 81 unknown | None |
Neighboring counties
- Onondaga County326 mg/L
- Cayuga County202 mg/L
- Jefferson County167 mg/L
- Oneida County160 mg/L
- Lewis County13 mg/L
- Wayne County344 mg/L
New York
The statewide median is 77 mg/L (moderately hard) from 2,847 sites.
New York hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.