Water hardness in Wilson County, NC
Water in Wilson County is soft, with a median of 23 mg/L (1.4 grains per gallon) across 12 monitoring sites.
Wilson County water at a glance
- HardnessSoft (23 mg/L, 1.4 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 23 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.4 gpg (1.3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Wilson County
Prefilled with Wilson County's measured local hardness of 23 mg/L (1.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Wilson County on the North Carolina map
Cities and communities in Wilson County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Wilson | 27 | Soft | 6 sites within 10 miles |
| Kenly | 19 | Soft | 7 sites within 10 miles |
| Elm City | 28 | Soft | 8 sites within 10 miles |
| Lucama | 22 | Soft | 9 sites within 10 miles |
| Stantonsburg | 27 | Soft | 12 sites within 10 miles |
| Black Creek | 28 | Soft | 7 sites within 10 miles |
| Saratoga | 29 | Soft | 12 sites within 10 miles |
| Sims | 22 | Soft | 7 sites within 10 miles |
Water quality in Wilson County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Wilson | City of Wilson | None detected | 0 lead · 15,026 unknown | None |
| Kenly | Town of Kenly | Not tested | 0 lead · 0 unknown | 13 |
| Elm City | Town of ELM City | Not tested | 0 lead · 0 unknown | 11 |
| Lucama | Town of Lucama | Not tested | 0 lead · 6 unknown | None |
| Stantonsburg | Town of Stantonsburg | Not tested | 0 lead · 240 unknown | None |
| Black Creek | Town of Black Creek | Not tested | 0 lead · 0 unknown | None |
| Saratoga | Town of Saratoga | Not tested | 0 lead · 0 unknown | None |
| Sims | Town of Sims | Not tested | 8 lead · 0 unknown | 1 |
Neighboring counties
- Nash County24 mg/L
- Greene County52 mg/L
- Edgecombe County29 mg/L
- Wayne County26 mg/L
- Johnston County26 mg/L
- Pitt County37 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.