Water hardness in Tyrrell County, NC
Water in Tyrrell County is moderately hard, with a median of 76 mg/L (4.4 grains per gallon) across 6 monitoring sites.
Tyrrell County water at a glance
- HardnessModerately hard (76 mg/L, 4.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 76 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.4 gpg (4.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Tyrrell County
Prefilled with Tyrrell County's measured local hardness of 76 mg/L (4.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Tyrrell County on the North Carolina map
Cities and communities in Tyrrell County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Columbia | 81 | Moderately hard | 3 sites within 10 miles |
Water quality in Tyrrell County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Columbia | Columbia Water System | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Washington County142 mg/L
- Perquimans County106 mg/L
- Pasquotank County136 mg/L
- Chowan County30 mg/L
- Hyde County220 mg/L
- Camden County14 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.