Water hardness in Hertford County, NC
Water in Hertford County is soft, with a median of 27 mg/L (1.6 grains per gallon) across 15 monitoring sites.
Hertford County water at a glance
- HardnessSoft (27 mg/L, 1.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 27 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.6 gpg (1.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Hertford County
Prefilled with Hertford County's measured local hardness of 27 mg/L (1.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Hertford County on the North Carolina map
Cities and communities in Hertford County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Ahoskie | 26 | Soft | 12 sites within 10 miles |
| Murfreesboro | 28 | Soft | 12 sites within 10 miles |
| Winton | 27 | Soft | 14 sites within 10 miles |
| Cofield | 26 | Soft | 11 sites within 10 miles |
| Harrellsville | 28 | Soft | 8 sites within 10 miles |
| Como | 29 | Soft | 13 sites within 10 miles |
Water quality in Hertford County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Ahoskie | Town of Ahoskie | None detected | 0 lead · 0 unknown | None |
| Murfreesboro | Town of Murfreesboro | None detected | 0 lead · 1,533 unknown | 1 |
| Winton | Town of Winton | Not tested | 0 lead · 0 unknown | None |
| Cofield | Village of Cofield | Not tested | 0 lead · 0 unknown | None |
| Harrellsville | Town of Harrellsville | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Gates County30 mg/L
- Bertie County33 mg/L
- Northampton County33 mg/L
- Chowan County30 mg/L
- Perquimans County106 mg/L
- Martin County45 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.