Water hardness in Stanly County, NC
Water in Stanly County is soft, with a median of 46 mg/L (2.7 grains per gallon) across 13 monitoring sites.
Stanly County water at a glance
- HardnessSoft (46 mg/L, 2.7 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 46 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.7 gpg (2.6 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Stanly County
Prefilled with Stanly County's measured local hardness of 46 mg/L (2.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Stanly County on the North Carolina map
Cities and communities in Stanly County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Albemarle | 25 | Soft | 9 sites within 10 miles |
| Norwood | 46 | Soft | 8 sites within 10 miles |
| Oakboro | 97 | Moderately hard | 4 sites within 10 miles |
| Badin | 25 | Soft | 11 sites within 10 miles |
| Stanfield | 60 | Moderately hard | 8 sites within 10 miles |
| Red Cross | 74 | Moderately hard | 6 sites within 10 miles |
| New London | 25 | Soft | 9 sites within 10 miles |
| Richfield | 25 | Soft | 9 sites within 10 miles |
| Misenheimer | 26 | Soft | 6 sites within 10 miles |
| Millingport (CDP) | 46 | Soft | county median |
| Aquadale (CDP) | 46 | Soft | 9 sites within 10 miles |
Water quality in Stanly County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Albemarle | City of Albemarle | 3 found (PFOA ND / PFOS 4.3 ppt) | 0 lead · 0 unknown | None |
| Norwood | Town of Norwood | 2 found (PFOA ND / PFOS 5.1 ppt) | 0 lead · 1,249 unknown | 3 |
| Oakboro | Town of Oakboro | Not tested | 0 lead · 561 unknown | 3 |
| Badin | Stanly Co-Palestine-Badin Dist | Not tested | 0 lead · 937 unknown | None |
| Stanfield | Stanfield #3-Polk Ford/Renee Ford | Not tested | 0 lead · 0 unknown | 8 |
| New London | Badin Shores Resort | Not tested | 0 lead · 0 unknown | 1 |
| Richfield | Pfeiffer-N Stanly Water Assoc | 3 found (PFOA ND / PFOS 5.5 ppt) | 0 lead · 0 unknown | None |
| Aquadale | Stanly Co-Aquadale Dist | Not tested | 0 lead · 295 unknown | 5 |
Neighboring counties
- Cabarrus County69 mg/L
- Montgomery County23 mg/L
- Anson County27 mg/L
- Union County49 mg/L
- Rowan County46 mg/L
- Mecklenburg County58 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.