Water hardness in Cleveland County, NC
Water in Cleveland County is soft, with a median of 21 mg/L (1.2 grains per gallon) across 10 monitoring sites.
Cleveland County water at a glance
- HardnessSoft (21 mg/L, 1.2 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 21 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.2 gpg (1.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Cleveland County
Prefilled with Cleveland County's measured local hardness of 21 mg/L (1.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Cleveland County on the North Carolina map
Cities and communities in Cleveland County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Shelby | 24 | Soft | 8 sites within 10 miles |
| Boiling Springs | 22 | Soft | 9 sites within 10 miles |
| Belwood | 10 | Soft | 5 sites within 10 miles |
| Grover | 20 | Soft | 3 sites within 10 miles |
| Light Oak (CDP) | 22 | Soft | 6 sites within 10 miles |
| Kingstown | 20 | Soft | 7 sites within 10 miles |
| Fallston | 21 | Soft | county median |
| Patterson Springs | 25 | Soft | 7 sites within 10 miles |
| Lawndale | 12 | Soft | 3 sites within 10 miles |
| Polkville | 12 | Soft | 3 sites within 10 miles |
| Lattimore | 22 | Soft | 10 sites within 10 miles |
| Waco | 19 | Soft | 3 sites within 10 miles |
| Casar | 10 | Soft | 5 sites within 10 miles |
| Mooresboro | 22 | Soft | 9 sites within 10 miles |
| Earl | 25 | Soft | 7 sites within 10 miles |
Water quality in Cleveland County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Shelby | City of Shelby | None detected | 0 lead · 0 unknown | None |
| Boiling Springs | Town of Boiling Springs | None detected | 0 lead · 15 unknown | 1 |
| Grover | Town of Grover | Not tested | 0 lead · 0 unknown | 2 |
| Lawndale | Town of Lawndale | Not tested | 0 lead · 0 unknown | None |
| Mooresboro | Daniel Morgan WTR District-NC | Not tested | 0 lead · 8 unknown | 1 |
Neighboring counties
- Rutherford County20 mg/L
- Lincoln County26 mg/L
- Gaston County27 mg/L
- Burke County17 mg/L
- Catawba County15 mg/L
- Polk County11 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.