Water hardness in Duplin County, NC
Water in Duplin County is soft, with a median of 45 mg/L (2.6 grains per gallon) across 28 monitoring sites.
Duplin County water at a glance
- HardnessSoft (45 mg/L, 2.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 45 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.6 gpg (2.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Duplin County
Prefilled with Duplin County's measured local hardness of 45 mg/L (2.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Duplin County on the North Carolina map
Cities and communities in Duplin County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Wallace | 40 | Soft | 9 sites within 10 miles |
| Warsaw | 62 | Moderately hard | 16 sites within 10 miles |
| Rose Hill | 42 | Soft | 7 sites within 10 miles |
| Beulaville | 42 | Soft | 7 sites within 10 miles |
| Magnolia | 53 | Soft | 6 sites within 10 miles |
| Kenansville | 42 | Soft | 12 sites within 10 miles |
| Greenevers | 43 | Soft | 10 sites within 10 miles |
| Potters Hill (CDP) | 40 | Soft | 6 sites within 10 miles |
| Teachey | 40 | Soft | 7 sites within 10 miles |
| Calypso | 60 | Moderately hard | 19 sites within 10 miles |
| Bowdens (CDP) | 63 | Moderately hard | 16 sites within 10 miles |
| Chinquapin (CDP) | 42 | Soft | 7 sites within 10 miles |
Water quality in Duplin County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Wallace | Town of Wallace | None detected | Not reported | 3 (1 open) |
| Warsaw | Town of Warsaw | Not tested | 0 lead · 4 unknown | None |
| Rose Hill | Town of Rose Hill | Not tested | 0 lead · 1 unknown | None |
| Beulaville | Town of Beulaville | Not tested | 0 lead · 568 unknown | None |
| Magnolia | Town of Magnolia | Not tested | 0 lead · 0 unknown | 2 |
| Kenansville | Town of Kenansville | Not tested | 0 lead · 0 unknown | None |
| Greenevers | Town of Greenevers | Not tested | 0 lead · 287 unknown | None |
| Teachey | Town of Teachey | Not tested | 0 lead · 0 unknown | None |
| Calypso | Town of Calypso | Not tested | 0 lead · 275 unknown | 1 |
| Chinquapin | Chinquapin Water Association | None detected | 0 lead · 0 unknown | None |
Neighboring counties
- Sampson County32 mg/L
- Lenoir County35 mg/L
- Onslow County110 mg/L
- Pender County55 mg/L
- Wayne County26 mg/L
- Jones County110 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.