Water hardness in Robeson County, NC
Water in Robeson County is soft, with a median of 18 mg/L (1 grains per gallon) across 17 monitoring sites.
Robeson County water at a glance
- HardnessSoft (18 mg/L, 1 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 18 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1 gpg (1 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Robeson County
Prefilled with Robeson County's measured local hardness of 18 mg/L (1.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Robeson County on the North Carolina map
Cities and communities in Robeson County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Lumberton | 16 | Soft | 6 sites within 10 miles |
| Red Springs | 16 | Soft | 4 sites within 10 miles |
| Pembroke | 16 | Soft | 4 sites within 10 miles |
| Fairmont | 22 | Soft | 8 sites within 10 miles |
| St. Pauls | 26 | Soft | 4 sites within 10 miles |
| Prospect (CDP) | 15 | Soft | 5 sites within 10 miles |
| Barker Ten Mile (CDP) | 18 | Soft | county median |
| Rowland | 14 | Soft | 5 sites within 10 miles |
| Parkton | 12 | Soft | 6 sites within 10 miles |
| Elrod (CDP) | 14 | Soft | 5 sites within 10 miles |
| Raemon (CDP) | 18 | Soft | 9 sites within 10 miles |
| Rennert | 18 | Soft | county median |
| Shannon (CDP) | 14 | Soft | 4 sites within 10 miles |
| Proctorville | 22 | Soft | 8 sites within 10 miles |
| Marietta | 25 | Soft | 4 sites within 10 miles |
| Wakulla (CDP) | 15 | Soft | 7 sites within 10 miles |
| McDonald | 23 | Soft | 4 sites within 10 miles |
| Lumber Bridge | 14 | Soft | 4 sites within 10 miles |
| Raynham | 23 | Soft | 4 sites within 10 miles |
| Orrum | 17 | Soft | 7 sites within 10 miles |
| Rex (CDP) | 14 | Soft | 4 sites within 10 miles |
Water quality in Robeson County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Lumberton | City of Lumberton | 4 found (PFOA 5.7 / PFOS 7.9 ppt) | 0 lead · 7,708 unknown | 1 |
| Red Springs | Town of Red Springs | None detected | 0 lead · 5 unknown | 1 |
| Pembroke | Town of Pembroke | Not tested | 0 lead · 0 unknown | None |
| Fairmont | Town of Fairmont | Not tested | 0 lead · 1,179 unknown | 1 |
| St. Pauls | Town of Saint Pauls | Not tested | 0 lead · 0 unknown | None |
| Rowland | Town of Rowland | Not tested | 0 lead · 765 unknown | 1 |
| Parkton | Town of Parkton | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Scotland County26 mg/L
- Hoke County9 mg/L
- Bladen County22 mg/L
- Cumberland County12 mg/L
- Columbus County21 mg/L
- Richmond County12 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.