Water hardness in Carroll County, MD

Water in Carroll County is moderately hard, with a median of 86 mg/L (5 grains per gallon) across 16 monitoring sites.

54% harder than the Maryland median (56 mg/L) 8th hardest of 24 counties
86mg/L
5 grains per gallon
Moderately hard

Carroll County water at a glance

  • HardnessModerately hard (86 mg/L, 5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 86 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5 gpg (4.8 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites16
Lab samples84
Sample years2000–2022
Middle 50% of sites59–164 mg/L
Groundwater (wells, springs)95 mg/L · 11 sites
Surface water (rivers, lakes)62 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Carroll County

Prefilled with Carroll County's measured local hardness of 86 mg/L (5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Carroll County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Carroll County

PlaceMedian mg/LClassBased on
Eldersburg (CDP) 61 Moderately hard 24 sites within 10 miles
Westminster 114 Moderately hard 12 sites within 10 miles
Taneytown 178 Hard 10 sites within 10 miles
Hampstead 69 Moderately hard 34 sites within 10 miles
Manchester 64 Moderately hard 23 sites within 10 miles
Sykesville 61 Moderately hard 21 sites within 10 miles
New Windsor 133 Hard 10 sites within 10 miles
Union Bridge 208 Very hard 7 sites within 10 miles

Water quality in Carroll County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Westminster City of Westminster 8 found (PFOA 12.4 / PFOS 6.9 ppt) 0 lead · 0 unknown 4
Taneytown City of Taneytown 6 found (PFOA 4.6 / PFOS 10.7 ppt) 0 lead · 741 unknown None
Hampstead Town of Hampstead 8 found (PFOA 9.1 / PFOS 5.7 ppt) 0 lead · 0 unknown None
Manchester Town of Manchester 6 found (PFOA 4.7 / PFOS ND ppt) 1 lead · 168 unknown None
New Windsor Town of New Windsor Not tested 0 lead · 629 unknown None
Union Bridge Town of Union Bridge Not tested 0 lead · 405 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next