Water hardness in Caroline County, MD

Water in Caroline County is soft, with a median of 38 mg/L (2.2 grains per gallon) across 33 monitoring sites.

32% softer than the Maryland median (56 mg/L) 19th hardest of 24 counties
38mg/L
2.2 grains per gallon
Soft

Caroline County water at a glance

  • HardnessSoft (38 mg/L, 2.2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 38 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.2 gpg (2.1 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites33
Lab samples174
Sample years2000–2023
Middle 50% of sites23–50 mg/L
Groundwater (wells, springs)37 mg/L · 28 sites
Surface water (rivers, lakes)41 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Caroline County

Prefilled with Caroline County's measured local hardness of 38 mg/L (2.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Caroline County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Caroline County

PlaceMedian mg/LClassBased on
Denton 38 Soft 25 sites within 10 miles
Federalsburg 50 Soft 15 sites within 10 miles
Greensboro 36 Soft 25 sites within 10 miles
Ridgely 41 Soft 25 sites within 10 miles
Preston 49 Soft 16 sites within 10 miles
Goldsboro 36 Soft 17 sites within 10 miles
Marydel 62 Moderately hard 39 sites within 10 miles
Henderson 50 Soft 28 sites within 10 miles
Williston (CDP) 41 Soft 27 sites within 10 miles
Hillsboro 44 Soft 27 sites within 10 miles
Choptank (CDP) 48 Soft 15 sites within 10 miles
West Denton (CDP) 41 Soft 27 sites within 10 miles

Water quality in Caroline County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Denton Town of Denton None detected 0 lead · 6 unknown None
Federalsburg Town of Federalsburg Not tested 0 lead · 1,127 unknown None
Greensboro Town of Greensboro Not tested 0 lead · 608 unknown None
Ridgely Town of Ridgely Not tested 0 lead · 0 unknown None
Preston Town of Preston Not tested 1 lead · 166 unknown 1
Henderson Town of Henderson Not tested 0 lead · 0 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next