Water hardness in Cecil County, MD

Water in Cecil County is soft, with a median of 54 mg/L (3.2 grains per gallon) across 24 monitoring sites.

about the same as the Maryland median (56 mg/L) 16th hardest of 24 counties
54mg/L
3.2 grains per gallon
Soft

Cecil County water at a glance

  • HardnessSoft (54 mg/L, 3.2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 54 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.2 gpg (3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites24
Lab samples402
Sample years2000–2025
Middle 50% of sites14–92 mg/L
Groundwater (wells, springs)38 mg/L · 19 sites
Surface water (rivers, lakes)84 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Cecil County

Prefilled with Cecil County's measured local hardness of 54 mg/L (3.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Cecil County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Cecil County

PlaceMedian mg/LClassBased on
Elkton 14 Soft 11 sites within 10 miles
Perryville 70 Moderately hard 25 sites within 10 miles
North East 19 Soft 15 sites within 10 miles
Rising Sun 83 Moderately hard 18 sites within 10 miles
Charlestown 32 Soft 20 sites within 10 miles
Chesapeake City 14 Soft 10 sites within 10 miles
Cecilton 61 Moderately hard 27 sites within 10 miles
Port Deposit 78 Moderately hard 29 sites within 10 miles

Water quality in Cecil County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Elkton Town of Elkton 8 found (PFOA 23.3 / PFOS 7.1 ppt) 0 lead · 295 unknown 2
Perryville Town of Perryville None detected 0 lead · 595 unknown 12
North East Town of North East 1 found 0 lead · 444 unknown 13
Rising Sun Town of Rising Sun Not tested 0 lead · 930 unknown 1
Charlestown Town of Charlestown Not tested 0 lead · 0 unknown 1
Cecilton Town of Cecilton Not tested 0 lead · 34 unknown 3
Port Deposit Port Deposit Not tested 0 lead · 0 unknown 1

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next