Water hardness in Talbot County, MD

Water in Talbot County is soft, with a median of 51 mg/L (3 grains per gallon) across 13 monitoring sites.

about the same as the Maryland median (56 mg/L) 17th hardest of 24 counties
51mg/L
3 grains per gallon
Soft

Talbot County water at a glance

  • HardnessSoft (51 mg/L, 3 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 51 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites13
Lab samples17
Sample years2000–2023
Middle 50% of sites27–104 mg/L
Groundwater (wells, springs)51 mg/L · 12 sites
Surface water (rivers, lakes)51 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Talbot County

Prefilled with Talbot County's measured local hardness of 51 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Talbot County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent County

Cities and communities in Talbot County

PlaceMedian mg/LClassBased on
Easton 51 Soft 14 sites within 10 miles
Trappe 31 Soft 14 sites within 10 miles
St. Michaels 51 Soft 5 sites within 10 miles
Tilghman Island (CDP) 51 Soft county median
Oxford 39 Soft 8 sites within 10 miles
Cordova (CDP) 45 Soft 23 sites within 10 miles

Water quality in Talbot County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Easton Easton Utilities None detected 0 lead · 3,074 unknown None
Trappe Town of Trappe Not tested 0 lead · 252 unknown None
St. Michaels Town of ST. Michaels Not tested 0 lead · 1,115 unknown 3
Oxford Town of Oxford Not tested 0 lead · 380 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next