Water hardness in Frederick County, MD

Water in Frederick County is soft, with a median of 1 mg/L (0.1 grains per gallon) across 420 monitoring sites.

98% softer than the Maryland median (56 mg/L) 24th hardest of 24 counties
1mg/L
0.1 grains per gallon
Soft

Frederick County water at a glance

  • HardnessSoft (1 mg/L, 0.1 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 1 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.1 gpg (0.1 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites420
Lab samples748
Sample years2000–2022
Middle 50% of sites1–72 mg/L
Groundwater (wells, springs)80 mg/L · 28 sites
Surface water (rivers, lakes)1 mg/L · 392 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Frederick County

Prefilled with Frederick County's measured local hardness of 1 mg/L (0.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Frederick County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Frederick County

PlaceMedian mg/LClassBased on
Frederick 1 Soft 395 sites within 10 miles
Ballenger Creek (CDP) 1 Soft 395 sites within 10 miles
Mount Airy 62 Moderately hard 11 sites within 10 miles
Urbana (CDP) 1 Soft 395 sites within 10 miles
Linganore (CDP) 1 Soft 395 sites within 10 miles
Brunswick 86 Moderately hard 8 sites within 10 miles
Thurmont 59 Soft 25 sites within 10 miles
Walkersville 1 Soft 393 sites within 10 miles
Spring Ridge (CDP) 1 Soft 394 sites within 10 miles
Middletown 139 Hard 22 sites within 10 miles
Emmitsburg 63 Moderately hard 19 sites within 10 miles
Braddock Heights (CDP) 1 Soft 400 sites within 10 miles
Adamstown (CDP) 1 Soft 395 sites within 10 miles
Jefferson (CDP) 138 Hard 17 sites within 10 miles
Myersville 232 Very hard 28 sites within 10 miles
New Market 1 Soft 396 sites within 10 miles
Point of Rocks (CDP) 88 Moderately hard 10 sites within 10 miles
Bartonsville (CDP) 1 Soft 394 sites within 10 miles
Woodsboro 174 Hard 13 sites within 10 miles
Buckeystown (CDP) 1 Soft 395 sites within 10 miles
Libertytown (CDP) 67 Moderately hard 9 sites within 10 miles
Monrovia (CDP) 1 Soft 392 sites within 10 miles
Sabillasville (CDP) 62 Moderately hard 26 sites within 10 miles
Rosemont 86 Moderately hard 10 sites within 10 miles
Burkittsville 88 Moderately hard 16 sites within 10 miles
Graceham (CDP) 58 Soft 24 sites within 10 miles
Green Valley (CDP) 1 Soft 392 sites within 10 miles
Lewistown (CDP) 65 Moderately hard 28 sites within 10 miles

Water quality in Frederick County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Frederick City of Frederick 1 found 20 lead · 5,804 unknown None
Mount Airy Town of Mount Airy 7 found (PFOA 12.7 / PFOS 6 ppt) 1 lead · 914 unknown None
Brunswick City of Brunswick None detected 0 lead · 2,217 unknown None
Thurmont Town of Thurmont 4 found (PFOA 15 / PFOS 48 ppt) 0 lead · 797 unknown None
Walkersville Town of Walkersville None detected 0 lead · 523 unknown None
Middletown Town of Middletown 8 found (PFOA 4.9 / PFOS 6.7 ppt) 0 lead · 84 unknown None
Emmitsburg Town of Emmitsburg Not tested 2 lead · 496 unknown None
Myersville Town of Myersville Not tested 0 lead · 36 unknown None
Woodsboro Town of Woodsboro Not tested 0 lead · 236 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next