Water hardness in Twin Falls County, ID

Water in Twin Falls County is very hard, with a median of 305 mg/L (17.8 grains per gallon) across 104 monitoring sites.

99% harder than the Idaho median (153 mg/L) 4th hardest of 44 counties
305mg/L
17.8 grains per gallon
Very hard

Twin Falls County water at a glance

  • HardnessVery hard (305 mg/L, 17.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 305 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 17.8 gpg (17.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites104
Lab samples586
Sample years2000–2023
Middle 50% of sites215–379 mg/L
Groundwater (wells, springs)316 mg/L · 99 sites
Surface water (rivers, lakes)237 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Twin Falls County

Prefilled with Twin Falls County's measured local hardness of 305 mg/L (17.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Twin Falls County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Twin Falls County

PlaceMedian mg/LClassBased on
Twin Falls 283 Very hard 61 sites within 10 miles
Kimberly 258 Very hard 54 sites within 10 miles
Buhl 252 Very hard 61 sites within 10 miles
Filer 316 Very hard 61 sites within 10 miles
Hansen 248 Very hard 46 sites within 10 miles
Hollister 307 Very hard 14 sites within 10 miles
Castleford 349 Very hard 24 sites within 10 miles
Murtaugh 231 Very hard 34 sites within 10 miles

Water quality in Twin Falls County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Twin Falls City of Twin Falls None detected 0 lead · 0 unknown None
Kimberly City of Kimberly Not tested 2 lead · 550 unknown 1
Buhl City of Buhl None detected 0 lead · 0 unknown None
Filer Filer Water Works Not tested 0 lead · 4 unknown 19
Hansen City of Hansen Not tested 0 lead · 0 unknown 1
Hollister City of Hollister Not tested 0 lead · 0 unknown None
Castleford City of Castleford Not tested 0 lead · 0 unknown None
Murtaugh City of Murtaugh Not tested 0 lead · 107 unknown 1 (1 open)

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next