Water hardness in Power County, ID

Water in Power County is very hard, with a median of 227 mg/L (13.3 grains per gallon) across 43 monitoring sites.

48% harder than the Idaho median (153 mg/L) 12th hardest of 44 counties
227mg/L
13.3 grains per gallon
Very hard

Power County water at a glance

  • HardnessVery hard (227 mg/L, 13.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 227 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 13.3 gpg (12.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites43
Lab samples117
Sample years2000–2018
Middle 50% of sites191–274 mg/L
Groundwater (wells, springs)230 mg/L · 42 sites
Surface water (rivers, lakes)158 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Power County

Prefilled with Power County's measured local hardness of 227 mg/L (13.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Power County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Power County

PlaceMedian mg/LClassBased on
American Falls 227 Very hard 17 sites within 10 miles
Arbon Valley (CDP) 243 Very hard 31 sites within 10 miles
Rockland 187 Very hard 5 sites within 10 miles

Water quality in Power County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
American Falls City of American Falls None detected 0 lead · 0 unknown None
Rockland City of Rockland Not tested 0 lead · 0 unknown None

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next