Water hardness in Washington County, ID

Water in Washington County is moderately hard, with a median of 102 mg/L (6 grains per gallon) across 39 monitoring sites.

33% softer than the Idaho median (153 mg/L) 31st hardest of 44 counties
102mg/L
6 grains per gallon
Moderately hard

Washington County water at a glance

  • HardnessModerately hard (102 mg/L, 6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 102 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6 gpg (5.7 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites39
Lab samples100
Sample years2000–2019
Middle 50% of sites63–285 mg/L
Groundwater (wells, springs)102 mg/L · 37 sites
Surface water (rivers, lakes)90 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Washington County

Prefilled with Washington County's measured local hardness of 102 mg/L (6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Washington County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Washington County

PlaceMedian mg/LClassBased on
Weiser 198 Very hard 27 sites within 10 miles
Cambridge 51 Soft 10 sites within 10 miles
Midvale 50 Soft 10 sites within 10 miles

Water quality in Washington County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Weiser City of Weiser None detected 0 lead · 1,285 unknown None
Cambridge City of Cambridge Not tested 0 lead · 65 unknown None
Midvale Midvale Water System Not tested 0 lead · 107 unknown None

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next