Water hardness in Boundary County, ID

Water in Boundary County is moderately hard, with a median of 110 mg/L (6.4 grains per gallon) across 21 monitoring sites.

28% softer than the Idaho median (153 mg/L) 30th hardest of 44 counties
110mg/L
6.4 grains per gallon
Moderately hard

Boundary County water at a glance

  • HardnessModerately hard (110 mg/L, 6.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 110 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.4 gpg (6.2 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites21
Lab samples96
Sample years2000–2023
Middle 50% of sites37–189 mg/L
Groundwater (wells, springs)121 mg/L · 17 sites
Surface water (rivers, lakes)110 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Boundary County

Prefilled with Boundary County's measured local hardness of 110 mg/L (6.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Boundary County on the Idaho map

Latah CountyIdaho CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Boundary County

PlaceMedian mg/LClassBased on
Bonners Ferry 121 Hard 11 sites within 10 miles
Moyie Springs 178 Hard 8 sites within 10 miles

Water quality in Boundary County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Bonners Ferry City of Bonners Ferry Not tested 0 lead · 189 unknown None
Moyie Springs City of Moyie Springs Not tested 0 lead · 48 unknown None

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next