Water hardness in Elmore County, ID

Water in Elmore County is moderately hard, with a median of 85 mg/L (5 grains per gallon) across 93 monitoring sites.

44% softer than the Idaho median (153 mg/L) 37th hardest of 44 counties
85mg/L
5 grains per gallon
Moderately hard

Elmore County water at a glance

  • HardnessModerately hard (85 mg/L, 5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 85 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5 gpg (4.8 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites93
Lab samples561
Sample years2000–2023
Middle 50% of sites59–219 mg/L
Groundwater (wells, springs)88 mg/L · 90 sites
Surface water (rivers, lakes)31 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Elmore County

Prefilled with Elmore County's measured local hardness of 85 mg/L (5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Elmore County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Elmore County

PlaceMedian mg/LClassBased on
Mountain Home 122 Hard 29 sites within 10 miles
Mountain Home AFB (CDP) 199 Very hard 40 sites within 10 miles
Glenns Ferry 224 Very hard 11 sites within 10 miles
Hammett (CDP) 224 Very hard 9 sites within 10 miles

Water quality in Elmore County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Mountain Home City of Mountain Home None detected 0 lead · 0 unknown 3
Glenns Ferry City of Glenns Ferry Not tested 0 lead · 0 unknown None

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next