Water hardness in Latah County, ID
Water in Latah County is moderately hard, with a median of 116 mg/L (6.8 grains per gallon) across 38 monitoring sites.
Latah County water at a glance
- HardnessModerately hard (116 mg/L, 6.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 116 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.8 gpg (6.5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Latah County
Prefilled with Latah County's measured local hardness of 116 mg/L (6.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Latah County on the Idaho map
Cities and communities in Latah County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Moscow | 108 | Moderately hard | 14 sites within 10 miles |
| Genesee | 118 | Moderately hard | 11 sites within 10 miles |
| Troy | 112 | Moderately hard | 15 sites within 10 miles |
| Potlatch | 94 | Moderately hard | 11 sites within 10 miles |
| Juliaetta | 120 | Moderately hard | 13 sites within 10 miles |
| Deary | 117 | Moderately hard | 11 sites within 10 miles |
| Kendrick | 116 | Moderately hard | 13 sites within 10 miles |
| Onaway | 94 | Moderately hard | 11 sites within 10 miles |
| Bovill | 132 | Hard | 3 sites within 10 miles |
| Princeton (CDP) | 87 | Moderately hard | 10 sites within 10 miles |
| Viola (CDP) | 94 | Moderately hard | 16 sites within 10 miles |
Water quality in Latah County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Moscow | Moscow Water Dept | None detected | 0 lead · 253 unknown | None |
| Genesee | City of Genesee | Not tested | 0 lead · 0 unknown | 1 |
| Troy | City of Troy | Not tested | 0 lead · 0 unknown | 5 |
| Potlatch | City of Potlatch | None detected | 0 lead · 0 unknown | 1 |
| Juliaetta | City of Juliaetta | Not tested | 0 lead · 0 unknown | 21 (1 open) |
| Deary | City of Deary | Not tested | 0 lead · 0 unknown | None |
| Kendrick | City of Kendrick | Not tested | 0 lead · 0 unknown | None |
| Bovill | Bovill Water Dept | Not tested | 0 lead · 11 unknown | None |
Neighboring counties
- Benewah County70 mg/L
- Nez Perce County114 mg/L
- Lewis County135 mg/L
- Clearwater County116 mg/L
- Shoshone County48 mg/L
- Kootenai County43 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.