Water hardness in Trempealeau County, WI
Water in Trempealeau County is moderately hard, with a median of 106 mg/L (6.2 grains per gallon) across 9 monitoring sites.
Trempealeau County water at a glance
- HardnessModerately hard (106 mg/L, 6.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 106 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.2 gpg (5.9 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Trempealeau County
Prefilled with Trempealeau County's measured local hardness of 106 mg/L (6.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Trempealeau County on the Wisconsin map
Cities and communities in Trempealeau County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Arcadia | 106 | Moderately hard | 3 sites within 10 miles |
| Trempealeau | 134 | Hard | 4 sites within 10 miles |
| Osseo | 30 | Soft | 3 sites within 10 miles |
| Galesville | 106 | Moderately hard | county median |
| Whitehall | 106 | Moderately hard | county median |
| Independence | 106 | Moderately hard | county median |
| Blair | 106 | Moderately hard | county median |
| Strum | 106 | Moderately hard | county median |
| Eleva | 106 | Moderately hard | county median |
| Ettrick | 106 | Moderately hard | county median |
| Pigeon Falls | 106 | Moderately hard | county median |
| Dodge (CDP) | 140 | Hard | 3 sites within 10 miles |
Water quality in Trempealeau County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Arcadia | Arcadia Waterworks | Not tested | 0 lead · 579 unknown | None |
| Trempealeau | Trempealeau Waterworks | Not tested | 0 lead · 0 unknown | None |
| Osseo | Osseo Waterworks | Not tested | 3 lead · 412 unknown | None |
| Galesville | Galesville Waterworks | Not tested | 0 lead · 70 unknown | 1 |
| Whitehall | Whitehall Waterworks | Not tested | 0 lead · 577 unknown | None |
| Independence | Independence Waterworks | Not tested | 0 lead · 180 unknown | None |
| Blair | Blair Waterworks | Not tested | 0 lead · 0 unknown | 1 |
| Strum | Strum Waterworks | Not tested | 0 lead · 0 unknown | None |
| Eleva | Eleva Waterworks | Not tested | 0 lead · 288 unknown | 2 |
| Ettrick | Ettrick Waterworks | Not tested | 0 lead · 0 unknown | None |
| Pigeon Falls | Pigeon Falls Waterworks | Not tested | 0 lead · 0 unknown | None |
| Dodge | Dodge Sanitary Dist 1 | Not tested | 0 lead · 0 unknown | 8 |
Neighboring counties
- Buffalo County186 mg/L
- Jackson County35 mg/L
- Eau Claire County75 mg/L
- La Crosse County228 mg/L
- Pepin County240 mg/L
- Monroe County175 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.