Water hardness in Langlade County, WI
Water in Langlade County is moderately hard, with a median of 110 mg/L (6.4 grains per gallon) across 12 monitoring sites.
Langlade County water at a glance
- HardnessModerately hard (110 mg/L, 6.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 110 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.4 gpg (6.2 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Langlade County
Prefilled with Langlade County's measured local hardness of 110 mg/L (6.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Langlade County on the Wisconsin map
Cities and communities in Langlade County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Antigo | 262 | Very hard | 3 sites within 10 miles |
| Post Lake (CDP) | 105 | Moderately hard | 22 sites within 10 miles |
| Elcho (CDP) | 96 | Moderately hard | 6 sites within 10 miles |
| White Lake | 136 | Hard | 11 sites within 10 miles |
| Summit Lake (CDP) | 110 | Moderately hard | county median |
Water quality in Langlade County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Antigo | Antigo Waterworks | None detected | 213 lead · 993 unknown | 5 (1 open) |
| Elcho | Elcho Sanitary District 1 | Not tested | 0 lead · 207 unknown | 3 |
| White Lake | White Lake Waterworks | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Menominee County150 mg/L
- Forest County95 mg/L
- Lincoln County44 mg/L
- Shawano County160 mg/L
- Oneida County47 mg/L
- Marathon County53 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.