Water hardness in Bainbridge Island, WA

Water in Bainbridge Island is moderately hard, with a median of 106 mg/L (6.2 grains per gallon) across 45 monitoring sites within 10 miles.

43% harder than the Washington median (74 mg/L) 11th hardest of 122 Washington towns Population 24,254
106mg/L
6.2 grains per gallon
Moderately hard

Bainbridge Island tap water at a glance

  • HardnessModerately hard (106 mg/L, 6.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo known lead lines; 2,307 lines are still of unknown material.Check your own pipe →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 106 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.2 gpg (5.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites45
Lab samples74
Sample years2000–2021
Middle 50% of sites72–188 mg/L
Groundwater (wells, springs)116 mg/L · 39 sites
Surface water (rivers, lakes)76 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Bainbridge Island

Prefilled with Bainbridge Island's measured local hardness of 106 mg/L (6.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Bainbridge Island tap water

City of Bainbridge Island is the main public water system for Bainbridge Island. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jun 2023 – Dec 2023. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Bainbridge Island

Water systemPFAS detectedHighest PFOA / PFOSTested
North Bainbridge Water
serves 10,000 people or fewer
None detected — Jun 2023 – Dec 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Bainbridge Island

City of Bainbridge Island reported 2,456 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 2,307 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
2,307unknown material (94%)
149not lead (6%)

Other water systems serving parts of Bainbridge Island

Water systemService linesTotal
North Bainbridge Water0 lead · 0 galvanized · 0 unknown1,902

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Bainbridge Island drinking water violations

EPA records show no health-based violations for City of Bainbridge Island since 2016.

Other water systems serving parts of Bainbridge Island

Water systemHealth-based violationsMonitoring/reporting
North Bainbridge WaterNone13

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Bainbridge Island

SiteTypeDistanceMedianSamplesYears
25N/02E-21J03
USGS Washington Water Science Center
Well 1.7 mi26 mg/L12008
25N/02E-09G03
USGS Washington Water Science Center
Well 2.9 mi27 mg/L12008
25N/02E-20K03
USGS Washington Water Science Center
Well 3.2 mi70 mg/L12008
25N/02E-20P03D1
USGS Washington Water Science Center
Well 3.2 mi116 mg/L12008
25N/02E-17C01
USGS Washington Water Science Center
Well 3.7 mi66 mg/L12008
25N/02E-19N02
USGS Washington Water Science Center
Well 4.6 mi69 mg/L12008

Water hardness in towns near Bainbridge Island

TownDistanceMedianClass
Seattle7 mi 28 mg/LSoft
Silverdale8 mi 98 mg/LModerately hard
Port Orchard9 mi 70 mg/LModerately hard
Poulsbo9 mi 89 mg/LModerately hard
Shoreline11 mi 98 mg/LModerately hard
White Center12 mi 67 mg/LModerately hard
Bremerton12 mi 66 mg/LModerately hard
Lake Forest Park13 mi 93 mg/LModerately hard
Burien14 mi 70 mg/LModerately hard
Edmonds14 mi 98 mg/LModerately hard

Kitsap County

Bainbridge Island is in Kitsap County, where the median is 88 mg/L (moderately hard) across 74 sites.

See all of Kitsap County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Bainbridge Island, WA water: common questions

Do I need a water softener in Bainbridge Island?

Probably not. Water measured around Bainbridge Island is 6.2 gpg (106 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 11,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Bainbridge Island's drinking water?

The main public water system serving Bainbridge Island in EPA records is City of Bainbridge Island. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Bainbridge Island?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next