Water hardness in Poulsbo, WA

Water in Poulsbo is moderately hard, with a median of 89 mg/L (5.2 grains per gallon) across 55 monitoring sites within 10 miles.

20% harder than the Washington median (74 mg/L) 23rd hardest of 122 Washington towns Population 12,171
89mg/L
5.2 grains per gallon
Moderately hard

Poulsbo tap water at a glance

  • HardnessModerately hard (89 mg/L, 5.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 89 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.2 gpg (5 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites55
Lab samples66
Sample years2000–2016
Middle 50% of sites70–146 mg/L
Groundwater (wells, springs)96 mg/L · 53 sites
Surface water (rivers, lakes)56 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Poulsbo

Prefilled with Poulsbo's measured local hardness of 89 mg/L (5.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Poulsbo tap water

City of Poulsbo is the main public water system for Poulsbo. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 12 samples taken Oct 2024 – Apr 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Poulsbo

Water systemPFAS detectedHighest PFOA / PFOSTested
North Peninsula
serves over 10,000 people
None detected — Aug 2025 – Oct 2025
North Perry Ave Water District
serves over 10,000 people
None detected — Oct 2023 – Apr 2024
Silverdale Water Dist 16
serves over 10,000 people
None detected — Apr 2024 – Jul 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Poulsbo

City of Poulsbo reported 4,077 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
4,077not lead (100%)

Other water systems serving parts of Poulsbo

Water systemService linesTotal
North PeninsulaNot reported—
North Perry Ave Water District0 lead · 240 galvanized · 3,614 unknown6,986
Silverdale Water Dist 160 lead · 0 galvanized · 29 unknown475

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Poulsbo drinking water violations

EPA records show no health-based violations for City of Poulsbo since 2016. It also had 5 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Poulsbo

Water systemHealth-based violationsMonitoring/reporting
North PeninsulaNone1
North Perry Ave Water DistrictNone0
Silverdale Water Dist 16None1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Poulsbo

SiteTypeDistanceMedianSamplesYears
DOGFISH CREEK NEAR POULSBO, WA
USGS Washington Water Science Center
Stream 0.8 mi74 mg/L92015
26N/01E-02K02
USGS Washington Water Science Center
Well 2.1 mi55 mg/L12016
26N/01E-36M01
USGS Washington Water Science Center
Well 2.9 mi65 mg/L12008
26N/01E-36J05 MW1-36
USGS Washington Water Science Center
Well 2.9 mi495 mg/L12000
26N/01E-36M08 MW1-37
USGS Washington Water Science Center
Well 3 mi257 mg/L12000
26N/01E-35J03 MW1-39
USGS Washington Water Science Center
Well 3 mi9 mg/L12000

Water hardness in towns near Poulsbo

TownDistanceMedianClass
Silverdale5 mi 98 mg/LModerately hard
Bainbridge Island9 mi 106 mg/LModerately hard
Shoreline14 mi 98 mg/LModerately hard
Port Orchard14 mi 70 mg/LModerately hard
Edmonds14 mi 98 mg/LModerately hard
Bremerton14 mi 66 mg/LModerately hard
Seattle16 mi 28 mg/LSoft
Mountlake Terrace16 mi 98 mg/LModerately hard
Lake Forest Park16 mi 93 mg/LModerately hard
Lynnwood17 mi 98 mg/LModerately hard

Kitsap County

Poulsbo is in Kitsap County, where the median is 88 mg/L (moderately hard) across 74 sites.

See all of Kitsap County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Poulsbo, WA water: common questions

Do I need a water softener in Poulsbo?

Probably not. Water measured around Poulsbo is 5.2 gpg (89 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 9,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Poulsbo's drinking water?

The main public water system serving Poulsbo in EPA records is City of Poulsbo. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Poulsbo?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next