Water hardness in Bremerton, WA

Water in Bremerton is moderately hard, with a median of 66 mg/L (3.8 grains per gallon) across 32 monitoring sites within 10 miles.

about the same as the Washington median (74 mg/L) 55th hardest of 122 Washington towns Population 45,450
66mg/L
3.8 grains per gallon
Moderately hard

Bremerton tap water at a glance

  • HardnessModerately hard (66 mg/L, 3.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 66 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.8 gpg (3.7 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites32
Lab samples49
Sample years2004–2021
Middle 50% of sites44–106 mg/L
Groundwater (wells, springs)106 mg/L · 15 sites
Surface water (rivers, lakes)45 mg/L · 17 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Bremerton

Prefilled with Bremerton's measured local hardness of 66 mg/L (3.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Bremerton tap water

City of Bremerton is the main public water system for Bremerton. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 16 samples taken Jul 2024 – Apr 2025. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBS
perfluorobutane sulfonic acid
4.9 ppt 1 of 16 samples —

Other water systems serving parts of Bremerton

Water systemPFAS detectedHighest PFOA / PFOSTested
West Sound Utility District #1
serves over 10,000 people
PFHxS, PFOA, PFPeA +1 more 5.7 / ND ppt Dec 2023 – Feb 2025
Naval Base Kitsap AT Bangor
serves over 10,000 people
None detected — Apr 2023 – Jan 2024
Naval Base Kitsap AT Bremerton
serves over 10,000 people
None detected — Apr 2023 – Feb 2024
North Perry Ave Water District
serves over 10,000 people
None detected — Oct 2023 – Apr 2024
Silverdale Water Dist 16
serves over 10,000 people
None detected — Apr 2024 – Jul 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Bremerton

City of Bremerton reported 20,315 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
20,315not lead (100%)

Other water systems serving parts of Bremerton

Water systemService linesTotal
West Sound Utility District #10 lead · 0 galvanized · 4,100 unknown7,220
Naval Base Kitsap AT Bangor0 lead · 0 galvanized · 1,049 unknown1,692
Naval Base Kitsap AT Bremerton0 lead · 0 galvanized · 134 unknown392
North Perry Ave Water District0 lead · 240 galvanized · 3,614 unknown6,986
Silverdale Water Dist 160 lead · 0 galvanized · 29 unknown475

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Bremerton drinking water violations

EPA records show no health-based violations for City of Bremerton since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Bremerton

Water systemHealth-based violationsMonitoring/reporting
West Sound Utility District #1None2
Naval Base Kitsap AT BangorNone1
Naval Base Kitsap AT Bremerton10
North Perry Ave Water DistrictNone0
Silverdale Water Dist 16None1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Bremerton

SiteTypeDistanceMedianSamplesYears
GORST CREEK AT W BELFAIR VALLEY RD AT GORST, WA
USGS Washington Water Science Center
Stream 1.2 mi60 mg/L22008
ANDERSON CREEK NEAR ANDERSON ROAD NEAR GORST, WA
USGS Washington Water Science Center
Stream 1.9 mi39 mg/L22008
24N/01E-22K02 OUA-206 BOTTOM
USGS Washington Water Science Center
Well 2.9 mi232 mg/L12021
24N/01E-22K02 OUA-206 SURFACE
USGS Washington Water Science Center
Well 2.9 mi233 mg/L12021
24N/01E-22J06 OUBT-720 BOTTOM
USGS Washington Water Science Center
Well 3 mi1770 mg/L12021
24N/01E-22J06 OUBT-720 SURFACE
USGS Washington Water Science Center
Well 3 mi1770 mg/L12021

Water hardness in towns near Bremerton

TownDistanceMedianClass
Port Orchard4 mi 70 mg/LModerately hard
Silverdale9 mi 98 mg/LModerately hard
Bainbridge Island12 mi 106 mg/LModerately hard
Poulsbo14 mi 89 mg/LModerately hard
Gig Harbor15 mi 45 mg/LSoft
Vashon15 mi 64 mg/LModerately hard
Artondale17 mi 45 mg/LSoft
White Center17 mi 67 mg/LModerately hard
Seattle18 mi 28 mg/LSoft
Burien18 mi 70 mg/LModerately hard

Kitsap County

Bremerton is in Kitsap County, where the median is 88 mg/L (moderately hard) across 74 sites.

See all of Kitsap County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Bremerton, WA water: common questions

Do I need a water softener in Bremerton?

Probably not. Water measured around Bremerton is 3.8 gpg (66 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Bremerton's drinking water?

The main public water system serving Bremerton in EPA records is City of Bremerton. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Bremerton?

It depends on what you want to remove. In Bremerton, EPA testing found PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next