Water hardness in Silverdale, WA
Water in Silverdale is moderately hard, with a median of 98 mg/L (5.7 grains per gallon) across 68 monitoring sites within 10 miles.
Silverdale tap water at a glance
- HardnessModerately hard (98 mg/L, 5.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 29 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 98 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.7 gpg (5.5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Silverdale
Prefilled with Silverdale's measured local hardness of 98 mg/L (5.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Silverdale tap water
Silverdale Water Dist 16 is the main public water system for Silverdale. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 20 samples taken Apr 2024 – Jul 2025. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Silverdale
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Bremerton serves over 10,000 people | PFBS | — | Jul 2024 – Apr 2025 |
| North Perry Ave Water District serves over 10,000 people | None detected | — | Oct 2023 – Apr 2024 |
| North Peninsula serves over 10,000 people | None detected | — | Aug 2025 – Oct 2025 |
| City of Poulsbo serves over 10,000 people | None detected | — | Oct 2024 – Apr 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Silverdale
Silverdale Water Dist 16 reported 475 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 29 lines are still of unknown material.
Other water systems serving parts of Silverdale
| Water system | Service lines | Total |
|---|---|---|
| City of Bremerton | 0 lead · 0 galvanized · 0 unknown | 20,315 |
| North Perry Ave Water District | 0 lead · 240 galvanized · 3,614 unknown | 6,986 |
| North Peninsula | Not reported | — |
| City of Poulsbo | 0 lead · 0 galvanized · 0 unknown | 4,077 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Silverdale drinking water violations
EPA records show no health-based violations for Silverdale Water Dist 16 since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Silverdale
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Bremerton | None | 2 |
| North Perry Ave Water District | None | 0 |
| North Peninsula | None | 1 |
| City of Poulsbo | None | 5 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Silverdale
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 25N/01E-14Q03 USGS Washington Water Science Center | Well | 2.3 mi | 86 mg/L | 1 | 2008 |
| 25N/01E-02J03 USGS Washington Water Science Center | Well | 2.5 mi | 76 mg/L | 1 | 2008 |
| 26N/01E-32E07 (F-MW23) USGS Washington Water Science Center | Well | 2.7 mi | 160 mg/L | 1 | 2001 |
| 26N/01E-36N17 MW1-33 USGS Washington Water Science Center | Well | 3.2 mi | 60 mg/L | 1 | 2000 |
| 25N/01E-26B02 USGS Washington Water Science Center | Well | 3.2 mi | 84 mg/L | 1 | 2008 |
| 26N/01E-31B07 (F-MW39) USGS Washington Water Science Center | Well | 3.2 mi | 88 mg/L | 1 | 2001 |
Water hardness in towns near Silverdale
| Town | Distance | Median | Class |
|---|---|---|---|
| Poulsbo | 5 mi | 89 mg/L | Moderately hard |
| Bainbridge Island | 8 mi | 106 mg/L | Moderately hard |
| Bremerton | 9 mi | 66 mg/L | Moderately hard |
| Port Orchard | 9 mi | 70 mg/L | Moderately hard |
| Seattle | 16 mi | 28 mg/L | Soft |
| Shoreline | 17 mi | 98 mg/L | Moderately hard |
| Edmonds | 18 mi | 98 mg/L | Moderately hard |
| White Center | 19 mi | 67 mg/L | Moderately hard |
| Lake Forest Park | 19 mi | 93 mg/L | Moderately hard |
| Mountlake Terrace | 20 mi | 98 mg/L | Moderately hard |
Kitsap County
Silverdale is in Kitsap County, where the median is 88 mg/L (moderately hard) across 74 sites.
See all of Kitsap County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Silverdale, WA water: common questions
Do I need a water softener in Silverdale?
Probably not. Water measured around Silverdale is 5.7 gpg (98 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Silverdale's drinking water?
The main public water system serving Silverdale in EPA records is Silverdale Water Dist 16. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Silverdale?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- How to tell if your home has a lead pipe29 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.