Water hardness in Burien, WA

Water in Burien is moderately hard, with a median of 70 mg/L (4.1 grains per gallon) across 8 monitoring sites within 10 miles.

about the same as the Washington median (74 mg/L) 43rd hardest of 122 Washington towns Population 50,730
70mg/L
4.1 grains per gallon
Moderately hard

Burien tap water at a glance

  • HardnessModerately hard (70 mg/L, 4.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 70 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.1 gpg (3.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites8
Lab samples64
Sample years2000–2016
Middle 50% of sites50–108 mg/L
Groundwater (wells, springs)51 mg/L · 3 sites
Surface water (rivers, lakes)96 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Burien

Prefilled with Burien's measured local hardness of 70 mg/L (4.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Burien tap water

Burien is served by more than one water system. These systems supply ZIP codes in Burien and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Burien

Water systemPFAS detectedHighest PFOA / PFOSTested
King County Water District #20
serves over 10,000 people
None detected — Mar 2024 – Dec 2024
Highline Water District
serves over 10,000 people
None detected — Aug 2024 – May 2025
Seattle Public Utilities
serves over 10,000 people
None detected — Jun 2023 – Dec 2023
King County Water District #49
serves over 10,000 people
None detected — Feb 2023 – Nov 2023
King County Water District #125
serves over 10,000 people
None detected — May 2023 – Feb 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Burien

Burien is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Burien

Water systemService linesTotal
King County Water District #200 lead · 141 galvanized · 0 unknown10,748
Highline Water District0 lead · 0 galvanized · 0 unknown18,780
Seattle Public Utilities0 lead · 0 galvanized · 0 unknown206,340
King County Water District #490 lead · 0 galvanized · 0 unknown4,281
King County Water District #1250 lead · 5 galvanized · 1,194 unknown3,416

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Burien drinking water violations

Burien is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Burien

Water systemHealth-based violationsMonitoring/reporting
King County Water District #20None0
Highline Water DistrictNone0
Seattle Public UtilitiesNone0
King County Water District #49None1
King County Water District #125None2

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Burien

SiteTypeDistanceMedianSamplesYears
DUWAMISH RIVER AT GOLF COURSE AT TUKWILA, WA
USGS Washington Water Science Center
Stream 4 mi31 mg/L212000–2001
LONGFELLOW CREEK AB GENESEE ST NR WEST SEATTLE, WA
USGS Washington Water Science Center
Stream 6.2 mi142 mg/L102015
23N/05E-17F01
USGS Washington Water Science Center
Well 6.8 mi51 mg/L12016
23N/05E-17F04 SWQA13
USGS Washington Water Science Center
Well 6.9 mi48 mg/L12016
MAY CREEK BELOW HONEY DEW CREEK NEAR RENTON, WA
USGS Washington Water Science Center
Stream 7.6 mi78 mg/L102015
MILL CREEK AT EARTHWORKS PARK AT KENT, WA
USGS Washington Water Science Center
Stream 8.5 mi96 mg/L102015

Water hardness in towns near Burien

TownDistanceMedianClass
White Center2 mi 67 mg/LModerately hard
SeaTac3 mi 77 mg/LModerately hard
Tukwila3 mi 87 mg/LModerately hard
Bryn Mawr-Skyway5 mi 87 mg/LModerately hard
Des Moines6 mi 58 mg/LSoft
Vashon7 mi 64 mg/LModerately hard
Renton7 mi 56 mg/LSoft
Mercer Island8 mi 80 mg/LModerately hard
Kent9 mi 52 mg/LSoft
Newcastle9 mi 65 mg/LModerately hard

King County

Burien is in King County, where the median is 61 mg/L (moderately hard) across 34 sites.

See all of King County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next