How to tell if your home has a lead pipe

Updated November 20, 2026 · Based on EPA and other public sources listed below · How we make our content

Short answer: find the pipe where water enters your home (near the meter or main shut-off). Scratch it gently with a key or coin and hold a magnet to it. Shiny silver scratch and no magnet pull: likely lead. Penny-colored scratch: copper. Magnet sticks: galvanized steel. Then check your utility's service line inventory and get your water tested.

Step 1: check your utility's inventory

Every community water system has had to build an inventory of service lines, the pipes that connect each building to the water main, and report it to its state. Many utilities publish a lookup map by address. Nationally, community water systems reported 1,964,747 lead and 993,560 galvanized lines that must be replaced, plus 22,533,658 lines of unknown material (23% of all lines), as of the first quarter of 2026.

Look up your town on our map to see your water system's numbers, or see lead pipes by state and city. Cities with the most reported lead service lines:

CityWater systemLead linesUnknownShare lead
Chicago, ILChicago150,750251,58531%
Cleveland, OHCleveland Public Water System144,19356,95433%
New York, NYNew York City System120,931124,91715%
Detroit, MICity of Detroit80,59539,07332%
Milwaukee, WIMilwaukee Waterworks65,33126,34141%
Indianapolis, INCitizens Water - Indianapolis56,76639,93515%
Minneapolis, MNMinneapolis38,34196238%
Cincinnati, OHCincinnati Public Water System34,6734515%
Buffalo, NYBuffalo Water Authority34,20835,83945%
South Bend, INSouth Bend Water Works27,00110,57255%
Providence, RIProvidence-City of25,7857,40232%
Columbus, OHColumbus Public Water System25,15565,2669%
Hammond, INHammond Water Works Department22,3804,51879%
Elkhart, INElkhart Public Works and Utilities19,7471,29358%
St. Paul, MNSaint Paul Regional Water Services19,7045,50021%
Grand Rapids, MIGrand Rapids19,43039424%
Syracuse, NYSyracuse City17,23916,09845%
Memphis, TNMemphis Light, Gas, & Water17,022164,5916%
Washington, DCDC Water16,93513,38812%
Philadelphia, PAPhiladelphia Water Department16,805351,5133%

If your line is listed as unknown, the utility hasn't identified it yet. It may or may not be lead. Ask whether they plan to inspect it, and do the check below.

Step 2: find your service line

The service line usually enters through the basement floor or wall, a crawl space, a utility closet or the garage, often next to the water meter or the main shut-off valve. Look at the short section of pipe that comes in before the meter or valve.

Step 3: the scratch and magnet test

PipeScratch with a key or coinMagnet
LeadSoft, scratches easily, shows shiny silverDoes not stick
CopperShows a copper (penny) colorDoes not stick
Galvanized steelHard to scratch, dull graySticks
Plastic (PEX, PVC, CPVC)White, black, blue or other colorsDoes not stick

Scratch gently: don't cut through the pipe. A galvanized pipe can still matter: if it was ever downstream of a lead pipe it can hold lead particles, which is why the rules require some galvanized lines to be replaced too. EPA's interactive Protect Your Tap guide walks through the same steps with photos.

The pipe inside your home is only part of the line. The section under the street may be a different material, so tell your utility what you found; some accept photos from customers for their inventory.

Step 4: test your water

You can't see, taste or smell lead in water, so testing is the only sure way to know. Ask your utility first, since many test for free. Otherwise use a certified lab from your state; EPA says testing costs between $20 and $100.

If you have a lead pipe

  • Use cold water for drinking, cooking and baby formula. Boiling does not remove lead.
  • Run your water before drinking if it has been sitting in the pipes for hours; ask your utility how long.
  • Use a filter certified to remove lead and replace cartridges on time.
  • Clean your faucet aerator regularly, since lead particles can collect there.
  • Ask about replacement. EPA's 2024 Lead and Copper Rule Improvements require most water systems to replace lead and galvanized-requiring-replacement lines within 10 years (the rule is being challenged in court). Ask your utility whether it has a replacement program.
  • Children and pregnancy: EPA's health goal for lead is zero. Ask your doctor about a blood lead test for young children.

In Canada? See lead in drinking water in Canada (Health Canada's 5 µg/L guideline).

Everyday steps to cut lead: why EPA says use cold tap water.

Frequently asked questions

How can I tell if my water pipe is lead?

Find the pipe where water enters your home, usually near the water meter or main shut-off valve. Gently scratch it with a key or coin. Lead is soft: the scratch shows shiny silver and a magnet won't stick. Copper scratches to a penny color and a magnet won't stick. If a magnet sticks, it is likely galvanized steel.

Are lead pipes common in houses built before 1986?

Yes. EPA says lead pipes are more likely in older cities and in homes built before 1986, when lead pipes were banned for new plumbing. Newer homes can still have lead solder or brass fixtures.

Does boiling water remove lead?

No. EPA says boiling water does not remove lead. Use cold water for drinking and cooking, and a filter certified to remove lead if you have a lead line.

How much does a lead water test cost?

EPA says testing costs between $20 and $100 at a certified laboratory. Many utilities test for free; ask yours first.

Is it safe to shower if my water has lead?

EPA says bathing and showering should be safe even if the water contains lead over its action level, because human skin does not absorb lead in water.

Sources

Related guides