Water hardness in Stillwater County, MT
Water in Stillwater County is moderately hard, with a median of 74 mg/L (4.3 grains per gallon) across 39 monitoring sites.
Stillwater County water at a glance
- HardnessModerately hard (74 mg/L, 4.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 74 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.3 gpg (4.1 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Stillwater County
Prefilled with Stillwater County's measured local hardness of 74 mg/L (4.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Stillwater County on the Montana map
Cities and communities in Stillwater County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Columbus | 87 | Moderately hard | 10 sites within 10 miles |
| Absarokee (CDP) | 58 | Soft | 18 sites within 10 miles |
| Park City (CDP) | 182 | Very hard | 16 sites within 10 miles |
| Reed Point (CDP) | 74 | Moderately hard | county median |
| Fishtail (CDP) | 51 | Soft | 19 sites within 10 miles |
| Nye (CDP) | 59 | Soft | 11 sites within 10 miles |
| Rapelje (CDP) | 74 | Moderately hard | county median |
Water quality in Stillwater County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Columbus | Town of Columbus | Not tested | 1 lead · 1,012 unknown | None |
| Absarokee | Absarokee Water and Sewer Dist | Not tested | 0 lead · 297 unknown | None |
| Rapelje | Rapelje Water District | Not tested | 0 lead · 0 unknown | 1 |
Neighboring counties
- Sweet Grass County90 mg/L
- Carbon County167 mg/L
- Golden Valley County483 mg/L
- Yellowstone County266 mg/L
- Park County58 mg/L
- Wheatland County305 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.