Water hardness in Treasure County, MT

Water in Treasure County is very hard, with a median of 326 mg/L (19 grains per gallon) across 9 monitoring sites.

108% harder than the Montana median (157 mg/L) 21st hardest of 56 counties
326mg/L
19 grains per gallon
Very hard

Treasure County water at a glance

  • HardnessVery hard (326 mg/L, 19 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 326 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 19 gpg (18.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites9
Lab samples26
Sample years2000–2018
Middle 50% of sites192–468 mg/L
Surface water (rivers, lakes)326 mg/L · 9 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Treasure County

Prefilled with Treasure County's measured local hardness of 326 mg/L (19.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Treasure County on the Montana map

Garfield CountyPowder River CountyFallon CountySweet Grass CountyLewis and Clark CountyRavalli CountyPetroleum CountyMeagher CountyBeaverhead CountyWheatland CountyCuster CountyDaniels CountyFlathead CountyBlaine CountyHill CountyPowell CountyMineral CountySilver Bow CountyMadison CountyGranite CountyCarbon CountyLincoln CountyDawson CountyStillwater CountyMissoula CountyGallatin CountyJudith Basin CountyPrairie CountyTeton CountyBig Horn CountyGlacier CountyValley CountyPark CountyWibaux CountyJefferson CountyBroadwater CountySheridan CountyCarter CountyYellowstone CountyPondera CountyPhillips CountyRosebud CountyToole CountyFergus CountyMcCone CountyLake CountyMusselshell CountyDeer Lodge CountyCascade CountyChouteau CountyGolden Valley CountySanders CountyRichland CountyLiberty CountyRoosevelt County

Cities and communities in Treasure County

PlaceMedian mg/LClassBased on
Hysham 167 Hard 3 sites within 10 miles

Water quality in Treasure County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Hysham Town of Hysham Not tested 2 lead · 1 unknown 7

Neighboring counties

Montana

The statewide median is 157 mg/L (hard) from 4,906 sites.

Montana hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next