Water hardness in Park County, MT
Water in Park County is soft, with a median of 58 mg/L (3.4 grains per gallon) across 133 monitoring sites.
Park County water at a glance
- HardnessSoft (58 mg/L, 3.4 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 58 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3.4 gpg (3.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Park County
Prefilled with Park County's measured local hardness of 58 mg/L (3.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Park County on the Montana map
Cities and communities in Park County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Livingston | 158 | Hard | 8 sites within 10 miles |
| Gardiner (CDP) | 46 | Soft | 50 sites within 10 miles |
| Pray (CDP) | 68 | Moderately hard | 6 sites within 10 miles |
| Emigrant (CDP) | 70 | Moderately hard | 7 sites within 10 miles |
| Clyde Park | 58 | Soft | county median |
| Wineglass (CDP) | 106 | Moderately hard | 6 sites within 10 miles |
| Wilsall (CDP) | 216 | Very hard | 3 sites within 10 miles |
| Corwin Springs (CDP) | 46 | Soft | 50 sites within 10 miles |
| Cooke City (CDP) | 56 | Soft | 44 sites within 10 miles |
| Jardine (CDP) | 46 | Soft | 50 sites within 10 miles |
| Springdale (CDP) | 53 | Soft | 7 sites within 10 miles |
| Silver Gate (CDP) | 58 | Soft | 43 sites within 10 miles |
| Pine Creek (CDP) | 67 | Moderately hard | 7 sites within 10 miles |
| South Glastonbury (CDP) | 70 | Moderately hard | 7 sites within 10 miles |
Water quality in Park County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Livingston | City of Livingston | None detected | 7 lead · 3,237 unknown | None |
| Gardiner | Gardiner Park Co Water Dist | Not tested | 0 lead · 159 unknown | None |
| Emigrant | Avalon Subdivision | Not tested | 0 lead · 0 unknown | None |
| Clyde Park | Clyde Park Water Dept | Not tested | 0 lead · 69 unknown | None |
| Wilsall | Wilsall Water District | Not tested | 0 lead · 2 unknown | 4 (1 open) |
| Corwin Springs | East Gate Work Camp | Not tested | 0 lead · 0 unknown | None |
| Cooke City | Cooke City Water District | Not tested | 1 lead · 32 unknown | None |
Neighboring counties
- Gallatin County143 mg/L
- Sweet Grass County90 mg/L
- Stillwater County74 mg/L
- Madison County122 mg/L
- Carbon County167 mg/L
- Broadwater County145 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.