Water hardness in Richland County, MT

Water in Richland County is very hard, with a median of 513 mg/L (30 grains per gallon) across 65 monitoring sites.

227% harder than the Montana median (157 mg/L) 7th hardest of 56 counties
513mg/L
30 grains per gallon
Very hard

Richland County water at a glance

  • HardnessVery hard (513 mg/L, 30 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 513 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 30 gpg (28.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites65
Lab samples418
Sample years2000–2026
Middle 50% of sites324–828 mg/L
Groundwater (wells, springs)498 mg/L · 14 sites
Surface water (rivers, lakes)513 mg/L · 51 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Richland County

Prefilled with Richland County's measured local hardness of 513 mg/L (30 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Richland County on the Montana map

Garfield CountyPowder River CountyFallon CountySweet Grass CountyLewis and Clark CountyRavalli CountyPetroleum CountyMeagher CountyBeaverhead CountyWheatland CountyCuster CountyDaniels CountyFlathead CountyBlaine CountyHill CountyPowell CountyMineral CountySilver Bow CountyMadison CountyGranite CountyCarbon CountyLincoln CountyDawson CountyStillwater CountyMissoula CountyGallatin CountyJudith Basin CountyPrairie CountyTeton CountyBig Horn CountyGlacier CountyValley CountyPark CountyWibaux CountyJefferson CountyBroadwater CountySheridan CountyCarter CountyTreasure CountyYellowstone CountyPondera CountyPhillips CountyRosebud CountyToole CountyFergus CountyMcCone CountyLake CountyMusselshell CountyDeer Lodge CountyCascade CountyChouteau CountyGolden Valley CountySanders CountyLiberty CountyRoosevelt County

Cities and communities in Richland County

PlaceMedian mg/LClassBased on
Sidney 482 Very hard 25 sites within 10 miles
Fairview 626 Very hard 14 sites within 10 miles
Fox Lake (CDP) 513 Very hard county median
Crane (CDP) 380 Very hard 23 sites within 10 miles
Savage (CDP) 420 Very hard 16 sites within 10 miles

Water quality in Richland County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Sidney City of Sidney None detected 1 lead · 141 unknown None
Fairview Town of Fairview Not tested 0 lead · 279 unknown None

Neighboring counties

Montana

The statewide median is 157 mg/L (hard) from 4,906 sites.

Montana hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next