Water hardness in Ravalli County, MT

Water in Ravalli County is soft, with a median of 35 mg/L (2 grains per gallon) across 120 monitoring sites.

78% softer than the Montana median (157 mg/L) 56th hardest of 56 counties
35mg/L
2 grains per gallon
Soft

Ravalli County water at a glance

  • HardnessSoft (35 mg/L, 2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 35 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2 gpg (2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites120
Lab samples385
Sample years2000–2026
Middle 50% of sites16–62 mg/L
Groundwater (wells, springs)75 mg/L · 27 sites
Surface water (rivers, lakes)28 mg/L · 93 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Ravalli County

Prefilled with Ravalli County's measured local hardness of 35 mg/L (2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Ravalli County on the Montana map

Garfield CountyPowder River CountyFallon CountySweet Grass CountyLewis and Clark CountyPetroleum CountyMeagher CountyBeaverhead CountyWheatland CountyCuster CountyDaniels CountyFlathead CountyBlaine CountyHill CountyPowell CountyMineral CountySilver Bow CountyMadison CountyGranite CountyCarbon CountyLincoln CountyDawson CountyStillwater CountyMissoula CountyGallatin CountyJudith Basin CountyPrairie CountyTeton CountyBig Horn CountyGlacier CountyValley CountyPark CountyWibaux CountyJefferson CountyBroadwater CountySheridan CountyCarter CountyTreasure CountyYellowstone CountyPondera CountyPhillips CountyRosebud CountyToole CountyFergus CountyMcCone CountyLake CountyMusselshell CountyDeer Lodge CountyCascade CountyChouteau CountyGolden Valley CountySanders CountyRichland CountyLiberty CountyRoosevelt County

Cities and communities in Ravalli County

PlaceMedian mg/LClassBased on
Hamilton 32 Soft 25 sites within 10 miles
Stevensville 61 Moderately hard 29 sites within 10 miles
Corvallis (CDP) 41 Soft 28 sites within 10 miles
Pinesdale 35 Soft 27 sites within 10 miles
Darby 12 Soft 24 sites within 10 miles
Florence (CDP) 56 Soft 26 sites within 10 miles
Victor (CDP) 68 Moderately hard 28 sites within 10 miles
Conner (CDP) 25 Soft 24 sites within 10 miles
Charlos Heights (CDP) 10 Soft 29 sites within 10 miles
Sula (CDP) 44 Soft 15 sites within 10 miles

Water quality in Ravalli County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Hamilton City of Hamilton 1 found 2 lead · 2,444 unknown None
Stevensville Town of Stevensville Not tested 0 lead · 911 unknown None
Corvallis Corvallis Mobile Village Not tested 0 lead · 0 unknown None
Pinesdale Town of Pinesdale None detected 0 lead · 0 unknown 1
Darby Town of Darby Not tested 0 lead · 2 unknown 1
Florence Bitterroot Pines TR CT Florence Not tested 0 lead · 0 unknown None

Neighboring counties

Montana

The statewide median is 157 mg/L (hard) from 4,906 sites.

Montana hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next